Search results: “6721”
Showing all 33 results
-
Stepper Motor Drivers
DRV8825 Stepper Motor Driver with Aluminum Heat Sink
SKU: 6721- Supply Voltage: 8.2 – 42 VDC.
- Current Capacity : 2.2A max(24V).
- Continuous current per phase: 1.5 A.
- Minimum Logic voltage: 2.5V.
- Maximum Logic Voltage: 5V.
- Microstep resolutions:Â full, 1/2, 1/4, 1/8, 1/16, and 1/32.
- Dimensions : 15 x 20 mm.
- Weight: 4 gm.
SKU: 6721 -
-
Orange Johnson Geared Motor
Orange 12V 20 RPM Johnson Geared DC Motor Grade A Quality Encoder Compatible
Orange Johnson Geared MotorOrange 12V 20 RPM Johnson Geared DC Motor Grade A Quality Encoder Compatible
SKU: 5721- Base Motor RPM: 18000
- Operating Voltage: 6-18 V
- Rated Voltage: 12 V
- Rated Torque: 328.3 N-cm
- Stall Torque: 1500 N-cm
- Gearbox Dimensions: 29×37 (LxW) mm
- Back shaft for Encoder Available
SKU: 5721 -
-
-
Programmers
PIC K150 USB Automatic Develop Microcontroller Programmer with ICSP Cable (Body width: 4 mm)
ProgrammersPIC K150 USB Automatic Develop Microcontroller Programmer with ICSP Cable (Body width: 4 mm)
SKU: 1378250- Support the most popular programming PIC chips, read, encryption and other features!
- No external power supply, communication, and power is only a USB cable to print complete, without any cable.
- PICSTARTPLUS much faster rate than programming.
- Can easily read the contents of the chip program area.
- Automatic programming verification.
- Comprehensive information prompts, allowing users to understand the working state.
SKU: 1378250 -
Programmers
PIC K150 USB Automatic Develop Microcontroller Programmer with ICSP Cable (Body width: 4 mm)
ProgrammersPIC K150 USB Automatic Develop Microcontroller Programmer with ICSP Cable (Body width: 4 mm)
SKU: 43286- Support the most popular programming PIC chips, read, encryption and other features!
- No external power supply, communication, and power is only a USB cable to print complete, without any cable.
- PICSTARTPLUS much faster rate than programming.
- Can easily read the contents of the chip program area.
- Automatic programming verification.
- Comprehensive information prompts, allowing users to understand the working state.
SKU: 43286 -
-
-
(ESC) Drone Speed Controller
T MOTOR AIR 40A ESC
SKU: 1092910- Output: Continuous 40A, Burst 60A up to 10 Secs.
- Input Voltage: 2-6 cells lithium battery or 5-18 cells NiCd/NIMh battery.
- BEC: 3A / 5V (Switch mode).
- Max Speed: 210,000rpm for 2 Poles BLM, 70,000rpm for 6 poles BLM, 35,000rpm for 12 poles BLM. (BLM: Brushless Motor)
SKU: 1092910 -
-
-
-
-
-
-
Current and Voltage
5A range Current Sensor Module ACS712
SKU: 23910- Low-noise analog signal path.
- Device bandwidth is set via the new FILTER pin.
- 5 µs output rise time in response to step input current.
- Small footprint, low-profile SOIC8 package.
- 2.1 kV RMS minimum isolation voltage from pins 1-4 to pins 5-8.
SKU: 23910 -
(ESC) Drone Speed Controller
XRotor Micro 30A BLHeli_S OneShot125 ESC with Wires for FPV Racing
SKU: 127287- Stick Programming: Stick Programming/BLHeliSuite
- Developed specifically for FPV drone racing multi-rotors
- Supports BLHeli-S, Oneshot125
- Compatible with various flight controllers and supports a signal frequency up to 621Hz
- Twisted pair cable to throttle which reduces crosstalk.
SKU: 127287 -
Current and Voltage
30A range Current Sensor Module ACS712
SKU: 12264- Low-noise analog signal path
- Device bandwidth is set via the new FILTER pin
- 5 µs output rise time in response to step input current
- Small footprint, low-profile SOIC8 package
- 2.1 kVRMS minimum isolation voltage from pins 1-4 to pins 5-8
- Supply Voltage: 4.5V~5.5V DC
- Measure Current Range: 30A
- Sensitivity: 100mV/A
SKU: 12264 -
(ESC) Drone Speed Controller
ReadytoSky Simonk 30A ESC with 3.5mm Banana Connector (Female)
SKU: 1427515- Cont Current: 30A
- Burst Current: 35A
- BEC Model: Linear mode
- Using Multi integrated circuit opted special program,
- Fast throttle response
- Firmware was optimized specific integrated circuit ally for disc motor, and it has a very good compatibility
SKU: 1427515 -
Current and Voltage
20A Range Current Sensor Module ACS712
SKU: 23911- Low-noise analog signal path
- Device bandwidth is set via the new FILTER pin
- 5 µs output rise time in response to step input current
- Small footprint, low-profile SOIC8 package
- 2.1 kVRMS minimum isolation voltage from pins 1-4 to pins 5-8
- Supply Voltage: 4.5V~5.5V DC
- Measure Current Range: 20A
- Sensitivity: 100mV/A
SKU: 23911 -
(ESC) Drone Speed Controller
ReadytoSky 30A 2-6S ESC 3.5mm Banana connector
SKU: 1432458- Model: 30A 2-6S ESC
- Current Range: 30A to 40A
- Voltage: 4 V-16.8V
- Connector: Female-Banana connector
- Specifically optimized firmware ESC, the ESC has a very good compatibility
- Highly intelligent, adaptive ability, extremely easy to use
SKU: 1432458 -
Orange Rectangular Gearbox Motor
Orange TT555 12V 4RPM Rectangular gearbox DC motor for DIY Project Encoder Compatible
Orange Rectangular Gearbox MotorOrange TT555 12V 4RPM Rectangular gearbox DC motor for DIY Project Encoder Compatible
SKU: 521210- Rated current (mA): ≤700.
- Rated power (W): 3.721.
- Rated Torque (N-cm): 846.2
- Rated speed: 4 RPM.
- Shaft length (mm): 27.
- Shaft diameter (mm): 8.
- Base motor RPM: 4500.
- Back shaft for Encoder Available
SKU: 521210 -
5 Cell (18.5V) & 6 cell (22.2V ~ 25.2V) Lipo
Orange 4200mAh 6S 35C/70C (22.2V) Lithium Polymer Battery Pack
5 Cell (18.5V) & 6 cell (22.2V ~ 25.2V) LipoOrange 4200mAh 6S 35C/70C (22.2V) Lithium Polymer Battery Pack
SKU: 23773- Model No:Â ORANGE 4200/6s-35C
- Capacity :Â 4200Â mAh.
- Weight:Â 621Â gm.
- Voltage: 22.2 V.
- Dimensions : 51 x 44 x 137 (mm ).
- Max Continuous Discharge : 35 C(147 A).
- Balance Plug: JST-XH.
SKU: 23773