Generic
Showing 673–720 of 6089 results
-
-
LED Module
DIP 3 Color LED Module
SKU: 44177- The use of plug-in full-color LED.
- RGB trichromatic limiting resistor to prevent burnout.
- Through the PWM adjusting, three primary colors can be mixed to obtain different colors.
- With a variety of single-chip interface.
- The working voltage: 5V.
- LED drive mode: common cathode driver
SKU: 44177 -
Voltage Regulator ICs
ICL7660 CMOS Voltage Converter IC
SKU: 579536- Simple Conversion of +5V Logic Supply to ±5V Supplies.
- Simple Voltage Multiplication (VOUT = (-) nVIN).
- Easy to Use – Requires Only 2 External Non-Critical Passive Components.
- No External Diode Over Full Temp. and Voltage Range.
- Pb-Free Plus Anneal Available (RoHS Compliant).
SKU: 579536 -
Logic Level Converter
CJMCU-4051 74HC4051 8 Channel Analog Multiplexer/Demultiplexer Breakout Board for Arduino
Logic Level ConverterCJMCU-4051 74HC4051 8 Channel Analog Multiplexer/Demultiplexer Breakout Board for Arduino
SKU: 445801.Wide Analog Input Voltage Range: +/-5V
2.Low “ON” Resistance: 80 ohm (type) at Vcc = 4.5V; 70 ohm (type) at Vcc = 6.0V; 60 ohm (type) at Vcc = 9.0V
3.Logic Level Translation: to enable 5V to communicate with +/-5V analog signals
4.Board Size: 30 x 19 mmSKU: 44580 -
-
Temperature & Humidity Sensor
MAX31865 PT100-PT1000 RTD Platinum Resistance Temperature Detector Module
Temperature & Humidity SensorMAX31865 PT100-PT1000 RTD Platinum Resistance Temperature Detector Module
SKU: 890201- Integration Lowers System Cost, Simplifies Design
- Efforts, and Reduces Design Cycle Time
- High Accuracy Facilitates Meeting Error Budgets
- 15-Bit ADC Resolution; Nominal Temperature
- Resolution 0.03125NC (Varies Due to RTD Nonlinearity)
- Total Accuracy Over All Operating Conditions:
SKU: 890201 -
-
-
Sleeves and Drag Chain
Nylon 16mm Expandable Braided Sleeve for Wire Protection-2M Length
SKU: 457743- Great for wrapping power/ground cable.
- Protect cables from wear & high temperature.
- Prolong the service life of the cable.
- Very easy to bend.
- Ultra expandable (150% of original size).
- Gives an attractive look with a clean install.
- Application: Bundle Wiring of Moving Assembles
SKU: 457743 -
Shield for Arduino
Data Logger module Logging Shield data Recorder Shield
SKU: 12191- SD card interface works with FAT16 or FAT32 formatted cards. 3.3v level shifter circuitry prevents damage to your SD card.
- Real-time clock (RTC) keeps the time going even when the Arduino is unplugged. The battery backup lasts for years.
- Included libraries and example code for both SD and RTC mean you can get going quickly Prototyping area for soldering connectors, circuitry or sensors.
- The onboard 3.3v regulator is both a reliable reference voltage and also reliably runs SD cards that require a lot of power to run.
- A dedicated and well-designed data logging shield for Arduino.
SKU: 12191 -
Stepper Motor Drivers
TMC2208 Stepper Motor Driver Module
SKU: 699623- Voltage range: 3.3-5V
- Maximum current: 1.2A per phase (continuous, with cooling), 2A peak per phase
- Works with 3.3V and 5V signals
- Comes with heatsink for better cooling
- Has StealthChop technology for quieter stepper motors
- Has SpreadCycl technology for smoother movements
SKU: 699623 -
-
-
-
Boost Converter
LM2577 DC-DC Step-Up Power Converter Module
SKU: 699580- Wide Input voltage: 3.5V-35V
- Output Voltage: 4-35V (Adjustable)
- Output current: rated current 3A MAX ( Heat-sink Needed)
- Conversion efficiency: Up to 92% (output voltage higher, the higher the efficiency)
- Switching Frequency: 50KHz
SKU: 699580 -
-
IR and RF Transmitters and Receivers
HX1838 VS1838 NEC Infrared IR Remote Control Sensor Module For Arduino
IR and RF Transmitters and ReceiversHX1838 VS1838 NEC Infrared IR Remote Control Sensor Module For Arduino
SKU: 31886- Crystal: the oscillation frequency of 455.
- Button: free height is less than 3mm, the force 200-350g, the life of more than 200 000.
- Photo-detector and preamplifier in one package.
- Internal filter for PCM frequency.
- Improved shielding against EMI.
- Don’t forget to add CR2025 Battery to your Cart as this remote does not come with a battery
SKU: 31886 -
PVC wire
5 Meter UL1007 28AWG PVC Electronic Wire (Black)
SKU: 528355The use of PVC coating blends these wires with special properties such as self – extinguishing and flame retardant, also Conditionally resistant to oils, solvents, acids, and dyes.
Self – extinguishing and flame retardant, also Conditionally resistant to oils, solvents, acids, and dyes…
SKU: 528355 -
Battery Harness
I Type 9V Battery, Clips Connector, Buckle with DC15CM, Black and Red Cable
SKU: 1121316- Supply voltage (V):9
- DC jack Size (mm):2.1
- Length of Cable (cm):10
- Length (mm):160
- Width (mm):26
- Height (mm):9
- Weight (gm):7
- Cable Length (cm):10
- Shipment Weight:0.01 kg
- Shipment Dimensions:5 × 5 × 3 cm
SKU: 1121316 -
Battery Pack Accessories & Holders
2 X 3 18650 Battery, Holder with 18.5MM, Bore Diameter
SKU: 1121236- Model: 18650 radiating battery spacer.
- Material: ABS/PC (Remarkable Flame Retardant Plastic).
- Bore Diameter: 18.5mm
- Combined them into many different sizes and shapes of the battery pack.
- Application: Design for Radiating Complex Battery Packs. Safe and Stable, Perfect Build for eBike!
SKU: 1121236 -
Sleeves and Drag Chain
Nylon 12mm Expandable Braided Sleeve for Wire Protection-2M Length
SKU: 457716- Great for wrapping power/ground cable.
- Protect cables from wear & high temperature.
- Prolong the service life of the cable.
- Very easy to bend.
- Ultra expandable (150% of original size).
- Gives an attractive look with a clean install.
- Application: Bundle Wiring of Moving Assembles
SKU: 457716 -
-
-
4S
4S 10A 18650 Lithium Battery Protection Board
SKU: 618341- Model; HX-4S-A10
- This protection board is suitable for 4 series Li-ion cell.
- Adopt a precision integrated circuit for fast and safe charging.
- Support overcharge protection, over-discharge protection, and short circuit protection.
SKU: 618341 -
Light Dependent Resistors (LDR), Light/color Sensor
12mm GL12528 Light Sensitive Photoresistor LDR (2Pcs)
Light Dependent Resistors (LDR), Light/color Sensor12mm GL12528 Light Sensitive Photoresistor LDR (2Pcs)
SKU: 611822- Diameter: 12 mm
- No. of pins: 2
- Type of mounting: PCB Through Hole
- Maximum Operating Temperature: +70˚C (Approx.)
- Dark resistance: 1-20MΩ
- Spectral peak: 560nm
- Maximum voltage: 250 VDC
- Maximum wattage: 200 mW
- Light resistance (10 Lux): 10-20 KΩ
- Dark resistance: 2 MΩ
- Resistance illumination: 3
- Response time: 20ms (Rise), 30ms (Down)
SKU: 611822 -
-