Holybro
Showing 1–48 of 80 results
-
-
-
-
GPS Modules
Holybro DroneCAN H-RTK F9P Helical High Precision GNSS Positioning System For Accurate Drone Positioning
GPS ModulesHolybro DroneCAN H-RTK F9P Helical High Precision GNSS Positioning System For Accurate Drone Positioning
SKU: 1735916- Processor: STM32G473
- GNSS Bands: B1I, B2I, E1B/C, E5b, L1C/A, L1OF, L2C, L2OF
- Positioning Accuracy(degrees): 3D FIX: 1.5 m / RTK: 0.01 m
- Navigation Update Rate: RAW: 20Hz Max RTK: 8Hz Max Moving Base RTK: 5Hz Max
- Connection: Board: SMA female Antenna: SMA male
- Working Voltage: 4.75V~5.25V
- Current Consumption (mA): ~250mA
SKU: 1735916 -
-
-
FPV Antennas and Trans-Receivers
Holybro High Precision RTK GNSS Antennas (CH3602A – 3 Bands)
SKU: 1777613- Model: Holybro High Precision RTK GNSS Antennas (CH3602A – 3 Bands)
- Support GPS, Glonass, Galileo, Beidou, QZSS, and SBAS signal reception
- A stable phase center guarantees the accuracy of positioning within the millimeter level
- Strong anti-interference ability to endure harsh operating environments
- 25g lightweight for lower power consumption
- IP67 ruggedized protection
SKU: 1777613 -
Drone Transmitter and Receiver
Holybro High Precision RTK GNSS Antennas (CSX627A -4 Bands)
SKU: 1777616- Model: Holybro High Precision RTK GNSS Antennas (CSX627A -4 Bands)
- Support GPS, Glonass, Galileo, Beidou, QZSS, IRNSS
and SBAS signal reception - Stable phase center guarantees the accuracy of
positioning within millimeter-level - Strong anti-interference ability to endure the
challenging operating environments
SKU: 1777616 -
-
-
Flight Controller & Accessories
Holybro Kakute F4 V2.4 Stacks + Tekko32 F4 Metal 4in1 65A ESC
SKU: 1777620- Model: Holybro Kakute F4 V2.4 Stacks + Tekko32 F4 Metal 4in1 65A ESC
- Fast F4 MCU: operating at 150MHz.
- PWM Frequency Range: Supports PWM frequencies ranging from 16k to 96k.
- Metal-Cased MOSFET: metal-cased MOSFET for efficient heat dissipation.
- On-Board Capacitance: on-board capacitance at 2068uF for effective noise filtering, enhancing signal quality.
- 3 oz Copper PCB Design
- Separate Drive & Control Circuit
SKU: 1777620 -
Flight Controller & Accessories
Holybro kakute F7 & amp- tekko 32 Blheli32 4 in 1 ESC stack
SKU: 1010945- Supports 3-6S Lipo input
- 35A continuous current, 50A burst
- MCU: STM32F745 32-bit processor
- IMU: ICM20689 (SPI)
- Barometer: BMP280
- Current Sensor: Approximately 130 amps maximum measurable value
- Supports Betaflight, Butterflight, and Cleanflight.
SKU: 1010945 -
-
-
-
Flight Controller & Accessories
Holybro Kakute H7 V2 Flight Controller
SKU: 1429630- MCU STM32H743 32-bit processor running at 480 MHz
- VTX ON/OFF Pit Switch – Switch can be enabled using USER1 in the Beta flight Mode tab.
- H7 processor @480 MHz
- Bluetooth onboard
- 8 Motors outputs in plugs
- 128 MB flash for logging
- VTX On/Off switch
SKU: 1429630 -
Flight Controller & Accessories
Holybro Kakute H743 Wing Flight Controller with Micro M10 GPS Module
SKU: 1720323- MCU: STM32H743, 480 MHz, 1MB RAM, 2MB Flash
- IMU: ICM-42688P (SPI3)
- Baro: BMP280 (I2C4)
- OSD: AT7456E (SPI2)
- Blackbox: MicroSD card slot on SDMMC2
- 7x Uarts (1,2,3,5,6,7,8) with built-in inversion.
SKU: 1720323 -
-
Flight Controller & Accessories
Holybro Micro APM flight controller
SKU: 1444799- One of the first open-source autopilot systems to use Invensense’s 6 DoF Accelerometer/Gyro MPU-6000
- Atmel’s ATMEGA2560 and ATMEGA32U-2 chips for processing and usb functions respectively
- Communication I2C, analog I/O.
- Module Telemetry, GPS, Power module
- Support 8-channel input
SKU: 1444799 -
-
-
Flight Controller & Accessories
Holybro Pix32 V6 FC Module Only
SKU: 1812213- High-performance STM32H743 Processor with more computing power & RAM
- New cost-effective design with the low-profile form factor
- A newly designed integrated vibration isolation system to filter out high-frequency vibration and reduce noise to ensure accurate readings
- IMUs are temperature-controlled by onboard heating resistors, allowing the optimum working temperature of IMUs
SKU: 1812213 -
Flight Controller & Accessories
Holybro Pix32 v6 Flight Controllers FC Module Standard Set
SKU: 1444801- High-performance STM32H743 Processor with more computing power & RAM
- New cost-effective design with the low-profile form factor
- A newly designed integrated vibration isolation system to filter out high-frequency vibration and reduce noise to ensure accurate readings
- IMUs are temperature-controlled by onboard heating resistors, allowing the optimum working temperature of IMUs
SKU: 1444801 -
Flight Controller & Accessories
Holybro Pixhawk 6C Aluminium Body (NO GPS NO Power Module)
SKU: 1792279- Model: Holybro Pixhawk 6C Aluminium Body (NO GPS NO Power Module)
- High-performance H7 Processor with clock speed up to 480 MHz
- New cost-effective design with low-profile form factor
- Redundant inertial measurement unit (IMU) from Bosch® & InvenSense®
- Newly designed integrated vibration isolation system to filter out high-frequency vibration and reduce noise to ensure accurate readings
- IMUs are temperature-controlled by onboard heating resistors, allowing optimum working temperature of IMUs
SKU: 1792279 -
-
Flight Controller & Accessories
Holybro Pixhawk PWM Cable for Tekko32 4in1 ESC (2.54 mm Dupont)
SKU: 1735921- Product: Pixhawk PWM Cable for Tekko32 4in1 ESC
- For Use With: Durandal, Pixhawk 32 v6 & V5, Pixhawk 4 Mini, Pixhawk 6C Mini, Pixhawk 6X/5X Standard
Baseboard or RPI CM4 Baseboard - Cable Length (cm): 20
- Connector: 2.54mm Dupont to JST SHR 8Pin
- Cable Size (AWG): 28
SKU: 1735921 -
Flight Controller & Accessories
Holybro Pixhawk PWM Cable for Tekko32 4in1 ESC (GHR 10 Pin)
SKU: 1735923- Product: Pixhawk PWM Cable for Tekko32 4in1 ESC
- For Use With: Pixhawk 4, Pixhawk 6C, Pixhawk 6X/5X with Mini Baseboard
- Cable Length (cm): 20
- Connector: JST GHR 10Pin to JST SHR 8Pin
- Cable Size (AWG): 28
SKU: 1735923