- High-speed optocoupler, high-speed without losing a step
- LV8729 chip, with over-current protection circuit, the maximum support 128 segments
- Automatic half-flow function
- A variety of input methods to meet a variety of interface needs
- The use of increased heat sink, good heat dissipation
- Support power outage recovery, filament outage detection, auto-off after finish printing, etc functions.
- Ability to manual/auto bed leveling.
- Wirelessly remote control, Cloud printing
- Stm32 based processor.
- 2560 and Ramps 1.4 are integrated into the board
- Support 12V-24V power input
- Arduino MEGA compatible Atmega2560 and FT232 processors compatible with all RAMPS class firmware
- Easy DISPLAY + SD-CARD connector, RepRapDiscount SmartController compatible pin header on board
- Easy connect MKS TFT to AUX-1
- 3x temperature ADC connectors for thermistors
- Up 5 motor driver with A4982
- 4x PWM enable mosfet outputs voltage selector switch for MainPower. (Bed, Extruder0, Extruder1, Fans)
- 4 layers PCB, optimize heat dissipation.