We have an ST-LINK programmer for STM8 and STM32. ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board. The programmer support multiple devices with the same I2C address.MCP2515 CAN Module can find it easy to control any CAN Bus device by SPI interface with your MCU.
Programmers
Showing all 17 results
-
-
Programmers
EZP2019+ High Speed USB SPI Programmer Support 24/25/26/93 Series Chip EEPROM Flash Bios Standard configuration
ProgrammersEZP2019+ High Speed USB SPI Programmer Support 24/25/26/93 Series Chip EEPROM Flash Bios Standard configuration
SKU: 1150751- Material: ABS+PCB
- Type: 1-3 (optional)
- USB interface: USB 2.0 interface
- Support 24/25/26/93 series chips
- Programmer size: 71 * 44 * 19mm
- Programmer weight: 37g
- Package size: 150 * 100 * 38mm
- Package weight: Type 1: 113g
SKU: 1150751 -
-
-
-
Programmers, Sensors on Sale
TW Link V2 Programmer For STM8 and STM32
SKU: 1268935- Voltage: 5V
- The wiring is very simple because the interface definition is marked directly on the aluminum housing protects
- Internal board of this programmer is with 500MA self-recovery fuse
- It’s convenient and practical, fast speed and stable
- The interface easy to use simple horns seat pitch of 2.54
- Weight: 10g
SKU: 1268935 -
Programmers
ICSP Universal Socket
SKU: 10061To ease user, Cytron has created this UIC-A so that user can use any programmer regardless of the development board. For example, a development board which uses PICkit2’s socket standard, which is 6-way header pins can be programmed with UIC000B by using the UIC-A!
SKU: 10061 -
Programmers
MCP2515 CAN Module TJA1050 Receiver SPI 51 Single Chip Program Routine Arduino
SKU: 43820- Support CAN V2.0B technical standard, communication rate 1Mb / S.
- Module 5V DC power supply, SPI interface protocol control
- 0 to 8 bytes long data field.
- 8MHZ crystal oscillator
- 120Ω terminal resistance
- Use High-speed CAN transceiver TJA1050
- Impedance matching, guaranteed drive capability, long-distance data transmission, prevent signal radiation
- The working current: typical 5mA, standby current 1 microamp. Except for the power indicator.
SKU: 43820 -
Programmers
ST Link V2 Programmer For STM8 and STM32
SKU: 83581- PCB installed inside of aluminum alloy U disk shell, portable, safe and reliable!
- Interface definition directly marked on the shell, clear, convenient and practical!
- 5V, 3.3V offers at the same time, allowing you to program your target board with both 5V and 3.3V
- Shell characters using laser engraving, never fade off! Permanent clarity!
- 500MA internal resettable fuse, complete protection of your expensive computer motherboard!
- SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector
- SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed
SKU: 83581 -
Programmers
ST-LINK/V2 in-circuit debugger/programmer for STM8 and STM32
SKU: 304904- 5V power supplied by a USB connector
- USB 2.0 full speed compatible interface
- USB standard A to mini B cable
- 1.65V to 5.5V application voltage supported on SWIM interface
- SWIM low speed and high-speed modes supported
SKU: 304904 -
Programmers
TL866A Universal Programmer Kit with 6 IC Adapters
SKU: 781391- Support a wide range of chips:
- All kinds of 26, 27, 28, 29, 37, 39, 49, 50 parallel ROM, EPROM, EEPROM;
- 24, 25, 35, 85, 93, 95 Series EEPROM, Serial parallel ROM chips;
- Fully supporting to the 48-PIN chips of 64Mbits capacity;
- It also supports a variety of models of 51 series of microcontroller,
- AVR microcontroller, including ATMEGA series, ATtiny Series, AT90XXX Series MCU;
- MICROCHIP PIC10 PIC12 PIC16 PIC18 MCU;
- programming of GAL programmable logic device, SRAM test, 54/74, and CMOS4000 series.
- Compatible with Window’s XP, 200/03/07/08/10/Vista
SKU: 781391 -
Programmers
TL866II Plus Universal Programmer Kit with 6 IC Adapters
SKU: 781392- Model: TL866II Plus
- With Multi-functional ICSP interface
- 40pin ZIF socket, fully automatic, support fast mode SPI
- USB interface for both data transfer and power supply
- With over-voltage and over current protection
- Supports the serial number of the chips two times development, built-in a variety of commonly used automatic numbering functions
- English Language Support
- It can program faster than another programmer 500%~1000%
SKU: 781392
