AVR Development Board is an 8-bit RISC single-chip microcontroller which was developed by Atmel in 1996. It includes ATmega32, ATTINY85, ATmega2560 Development Board. It has a built-in power supply circuit,16×2 LCD support, RS232 port for serial interface with PC/Serial devices. This board lets you concentrate on programming, testing, and optimizing your code, and thereby your overall project.
AVR Development Board
Showing all 10 results
-
-
AVR Development Board
MICROCHIP ATMEGA328PB-XMINI Evaluation Kit, Mini, ATmega328PB Xplained Mini, 8-Bit
AVR Development BoardMICROCHIP ATMEGA328PB-XMINI Evaluation Kit, Mini, ATmega328PB Xplained Mini, 8-Bit
SKU: 1417171- Product: ATMEGA328PB-XMINI Evaluation Kit, Mini, ATmega328PB Xplained Mini, 8-Bit
- Architecture: megaAVR
- Silicone Manufacturer: Atmel
- Silicon Family Name: ATmega
- No. of Bits: 8bit
SKU: 1417171 -
AVR Development Board
MICROCHIP DM080104 AVR Embedded Daughter Board AND Modules
SKU: 1417172- Product: MICROCHIP DM080104 AVR Embedded Daughter Board AND Modules
- Controlled by the same ATtiny1617 MCU
- 5×6 Surface diamond pattern with dedicated driven shield
- LEDs to indicate position and mode
- MCP23017 LED driver
SKU: 1417172 -
AVR Development Board
MICROCHIP DM320115 Evaluation Board, Curiosity Nano MPLAB X IDE, On-Board Debugger
AVR Development BoardMICROCHIP DM320115 Evaluation Board, Curiosity Nano MPLAB X IDE, On-Board Debugger
SKU: 1417173- Product: MICROCHIP DM320115 Evaluation Board, Curiosity Nano MPLAB X IDE, On-Board Debugger
- Core Architecture: AVR
- Silicon Family Name: ATmega
- Silicon Manufacturer: Microchip
- No. of Bits: 8bit
SKU: 1417173 -
AVR Development Board
ATTINY85 USB Development Board
SKU: 31126- Support for the Arduino IDE 1.0 + (OSX/Windows/Linux).
- Power via USB or External Source or 7-16 v to 5 v (automatic selection).
- The Onboard, 150 ma 5 v Regulator.
- Built-in USB and serial were debugging).
- 6 I/O Pins (2 inform the for USB only if your program actively communicates over USB, otherwise you can use all 6 even if you are programming via USB).
- 8 k Flash Memory (about 6 k after bootloader).
- The I2C and SPI (vis USI).
- The Power LED and the Test/Status LEDs.
SKU: 31126 -
AVR Development Board
Digispark ATTINY85 Mini USB Development Board
SKU: 31117- High Performance, Low Power AVR® 8-Bit Microcontroller
- Non-volatile Program and Data Memories
- 512 Bytes In-System Programmable EEPROM
- 512 Bytes Internal SRAM
- USI – Universal Serial Interface (12C, SPI, 1-wire) with Start Condition Detector
- 10-bit ADC
- 4 Single Ended Channels
- Two Differential ADC Channel Pairs with Programmable Gain (1x, 20x)
- Low Power Consumption
- Active Mode:1 MHz, 1.8V: 300 µA
SKU: 31117 -
AVR Development Board
SmartElex ATmega2560 Development Board
SKU: 245283- Microcontroller: ATMEGA2560 with 16 MHz crystal with On-Board USBASP Programmer.
- Power: 7 to 15 VDC with Reverse Polarity Protection.
- 2.4GHz ZigBee (XBee) wireless module adaptor
- 2×16 Character Alphanumeric LCD.
- SD card Holder.
- CH340G USB to Serial converter.
- ESP8255 Adaptor interface with USB to Serial Converter.
SKU: 245283 -
AVR Development Board
SmartElex ATmega2560 Development Board with LCD1602 LCD Display-Upgraded
SKU: 631968- Microcontroller: ATMEGA2560 with 16 MHz crystal with On-Board USBASP Programmer.
- Power: 7 to 15 VDC with Reverse Polarity Protection.
- 2.4GHz ZigBee (XBee) wireless module adaptor
- 2×16 Character Alphanumeric LCD.
- SD card Holder.
- CH340G USB to Serial converter.
- ESP8255 Adaptor interface with USB to Serial Converter.
SKU: 631968 -
AVR Development Board
SmartElex ATmega32 Development Board on-board Programmer
SKU: 80650- Onboard 5V regulator (78M05) circuit.
- On-Board power supply on-off switch
- Power Status LED (RED)
- User LED D0, D1 connected to any port pin through D0, D1 Jumper respectively.
- User Switch SW1, SW2 connected to any port pin through SW1, SW2 Jumper respectively.
- Onboard 12 MHz crystal
- Port extensions for all ports with detailed pin labeling for easy identification of pins
- Onboard USB TO Serial – CH340 Chip.
- On-board Micro USB USBASP for loading HEX file.
- Servo motor Connector (Run only up to 300mA).
SKU: 80650