MultiRotor Controller
OMNIBUS F4 V2 PRO Flight Controller with SD Card Slot & BEC
Product Code(SKU): 57107₹ 2,690.00 (inc GST)- Dimensions: 37 x 37 x 10 mm(L x H x W)
- Weight: 12 gm.
- SPI Gyro MPU6000
- MicroSD Blackbox
- F4 Processor (F405)
- 5v3a SBEC
- Built-in Current Sensor
- On-Board OSD (controlled by Beta flight, FC over SPI bus)
- On-Board Video Filter (only can supply 5V to VTX and Camera)
- On-Board Voltage Regulator and Power supply (BEC)
FPV Ublox NEO-M8N GPS amp Compass Support DJI Naza M V1 & V2 Lite Flight Controller
Product Code(SKU): 29463₹ 1,990.00 (inc GST)- Receiver type 72-channel Ublox M8 engine.
- GPS/QZSS L1 C/A, GLONASS L10F, BeiDou B1.
- SBAS L1 C/A: WAAS, EGNOS, MSAS.
- Sensitivity2 Tracking & Nav: –167 dBm.
- OMA SUPL & 3GPP compliant.
- Oscillator TCXO (NEO-M8N/Q).
- RTC crystal Built-In.
- Lowest noise figure (NEO-M8N/Q).
- Anti-jamming Active CW detection and removal. Extra.
- Onboard SAW bandpass filter (NEO-M8N/Q).
- Memory ROM (NEO-M8M/Q) or Flash (NEO-M8N).
- Supported antennas Active and passive.
5.8G and 2.4G 151CH OTG WiFi dual FPV AV Receiver for IOS & Android Smart Phones
Product Code(SKU): 57090₹ 2,890.00 (inc GST)- Input voltage: 5V
- Working current: 450mA
- Frequency range: 5.645-5.945GHz
- Frequency points: 151
- Video Frequency: 5.8Ghz
- Wifi frequency: 2.4Ghz
- Charging status: red light and green light together; Full power, red light off, green light.
Naze 32 Full REV6 Flight Controller with Compass & Barometer
Product Code(SKU): 57248₹ 1,749.00 (inc GST)- Dimensions: 36×36 mm.
- Weight: 5.3 gm (board only) /24 gm (whole Assembly).
- 2000 degrees/second 3-axis MEMS gyro + accelerometer (MPU6500).
- Input voltage: Max 16V on input rail and up to 35V 6s on the voltage sense line.
- Fully pinout compatible with rev5 accessories (OSDoge etc).
- SBUS Inverter.
- Sonar pads w/resistors added for direct connection to 5V sonar.
- MS5611 barometer.
- 128mbit flash.
PDB-XT60 with BEC 5V and 12V
Product Code(SKU): 57854₹ 399.00 (inc GST)- Built-in XT60 Socket
- Total 6 pairs ESC solder tabs are fit for H or X type frame
- 5V and 12V Output LED indicators
- Regulated 5V and 12V outputs
- Short circuit tolerantInput voltage range: 9 – 18V DC (3S-4S LiPoly operation)
- Output continuous current: 25Ax4 or 15Ax6
- Output Peak current (10 seconds/minute): 30Ax4 or 20Ax6
- BEC 5V output: 5V/2A (Max.2.5A 10s/minute)
- Output Ripple: 40mV (VIn= 16V, VOut= 5V@2A load)
- Short-circuit tolerant: 5 seconds/minute
F3 Brushed Flight Control Board Based On SP RACING F3 EVO Brush for Micro FPV Frame
Product Code(SKU): 45650₹ 1,090.00 (inc GST)- UART1/2 Output: 5V
- UART3 Output: 3.3V
- Supported Receiver Input Signal: PPM, SBUS, DSM
- PCB Thickness: 1.2mm
- Dimensions:32 x 22 x 2 (LxWxH)
- Weight: 5 gm
- Run on SP RACING F3 EVO firmware 32 brush flight control
- Large current NMOS transistors, operating current can reach 10A or higher
- Each machine is equipped with freewheeling diodes
- Support PPM, SBUS, DSM receiver input signal
- Battery voltage detection and buzzer interface
- Support 1S (4.2V) and 2S (8.4V) power supply, 2S power can bring a more violent flying experience
- Use STM32F303CCT6 + MPU6500, advanced hardware platform F3 for higher flight stability
PX4FLOW V1.3.1 Optical Flow Sensor Smart Camera
Product Code(SKU): 29466₹ 5,990.00 (inc GST)- STM32F405, 168 MHz Cortex M4F (GFLOPS 128 + 64 KB RAM)
- 752 x 480 MT9V034 image sensor, L3GD20 3-axis Gyro
- 16 mm M12 lens (IR block filter)
- Size: 45.5 mm x 35mm
- Power supply: 5V
- Current Consumption: 115 mA.
- Package weight: 60 gm.
