RAMPS
Showing all 5 results
-
LCD Displays
12864B V 2.0 Graphic Blue Color Backlight LCD Display Module
SKU: 43376- Based on ST7920
- 128 X 64 pixels
- Operating voltage: 5V
- Led Backlight
- Module size: 93mm x 70mm x 12mm
- Viewing Area: 72mm x 40mm
- Display mode TN/STN
- Display type Positive Transflective
- Backlight VDD5.0V, Idd250mA
- Operating temperature Indoor
- Driving voltage Single power
- Driving method 1/64 duty,1/9 bias, VOP10.5V, VDD5.0V
- Type COB (Chip On Board)
- Number of data line 8-bit parallel
- Connector Pin / ZEBRA
SKU: 43376 -
3D Printer Display and Controller
2004 LCD Display RepRapDiscount Smart Controller with Adapter
SKU: 12060- RAMPS 1.4 2004 LCD Display intelligent controller.
- LED background light control circuit, a small function of the intelligent controller,
- With pin short time to decide on all LED turn or steering 30 seconds
- You can turn on the light time to do the long or short form of the adjustment TRIMM R4100K from 10 seconds to 2 minutes.
- Plug and play on the RAMPS, but need to modify the firmware to support.
- The product comes encoder parameter adjustment can be achieved, and the file selection print.
- With an SD card base on the back, put slicing file into the SD card and select the file on the LCD, then can be printing.
SKU: 12060 -
3D Printer Display and Controller
3D printer 128×64 Smart LCD controller for ramps 1.4
SKU: 12072- RAMPS 1.4 LCD 12864 intelligent controller.
- With an SD card base on back.
- Large screen display 128×64 LCD (3.2″)
- SD card slot at the back, able to directly select a file and print
- The product comes encoder parameter adjustment can be achieved, and the file selection print
- Plug & play on the RAMPS, but need to modify the firmware to support.
- LCD 12864 Smart Controller fully supported by Marlin Firmware.
SKU: 12072 -
Stepper Motor Drivers
3D Printer Controller Board RAMPS 1.4 Arduino Mega Shield RepRap Prusa Model
SKU: 16048- Supply Voltage: 12V
- Standard interfaces (as that of the extruder)
- Reserved GCI like I2C and RS232
- 3 MOSFET’s are applied to the heater/ fan and thermistor circuit.
- Another 5A added to protect the component parts.
- An 11A fuse is added to the hotbed.
- Support 5 stepper drive board
SKU: 16048 -
