1 Channel Relay Module, 30A with Optocoupler, Isolation 24V Supports, High and Low Triger,(with Guide Rail)

Availability:

In stock


SKU: 1121225
  1. Channel: 1 channel
  2. Comes with GUIDE RAIL
  3. Relay Voltage: 24V
  4. High impedance controller pin
  5. Pull-down circuit for the avoidance of malfunction
  6. One normally closed contact and one normally open contact
  7. Triode drive, increasing relay coil

 429.00

(inc GST)

In stock

Purchase this product now and earn 5 Robu Points!
Brand: Generic
Category: Relay Switch Modules

This 1 channel 24V 30A relay control board module with optocoupler modules is compliant with international safety standards, control and load areas isolation trenches it has a single relay a genuine.

The inputs of 1 Channel 24V 30A Relay Module are isolated to protect any delicate control circuitry.

The power supply and relay instructions, lit, a disconnect are off. The input signal, signal, common Terminal and start conducting. It can be used as a single chip module for appliance control and work with both DC or AC signals where you can control the 220V AC load.

A wide range of microcontrollers such as Arduino, AVR, PICARM and so on can control it.

This module comes with a Guide rail situated on the backside of it so we can adjust the module to a superior location.

Note: On the high level and low level-triggered mode, friends who do not understand, have a look
  • High-level trigger refers to the signal voltage between input and trigger, can be understood as a signal input with VCC cathode short-circuit triggered away;
  • Low-level trigger refers to the signal voltage between the input terminal and Earth OV trigger, can be understood as a signal input terminal and the GND negative electrode short circuit triggered is a way  1-channel relay module connection.

 


Features :

  1. High impedance controller pin
  2. Pull-down circuit for the avoidance of malfunction
  3. One normally closed contact and one normally open contact
  4. Triode drive, increasing relay coil
  5. Power supply indicator lamp
  6. Control indicator lamp
  7. With 4 fixed screw holes, hole diameter 3.1mm, convenient installation, and fixation

Package Include :

1 x 1 channel 24V 30A relay control board module (Guide rail)

Trigger Voltage (VDC)

24

Switching Voltage (VAC)

[email protected]

Switching Voltage (VDC)

[email protected]

15 Days Warranty

This item is covered with a standard warranty of 15 days from the time of delivery against manufacturing defects only. This warranty is given for the benefit of Robu customers from any kind of manufacturing defects.  Reimbursement or replacement will be done against manufacturing defects.


What voids warranty:

If the product is subject to misuse, tampering, static discharge, accident, water or fire damage, use of chemicals & soldered or altered in any way.

Based on 0 reviews

0.0 overall
0
0
0
0
0

Be the first to review “1 Channel Relay Module, 30A with Optocoupler, Isolation 24V Supports, High and Low Triger,(with Guide Rail)”

There are no reviews yet.

Questions and answers of the customers

There are no questions yet. Be the first to ask a question about this product.

Only registered users are eligible to enter questions