This module consists of a 5mm RGB LED and three 150Ω limiting resistors to prevent burnout. Adjusting the PWM signal on each colour pin will result in different colours.
This is a DIP 3 Color LED Module. Through the PWM adjusting, three primary colours can be mixed to obtain different colours.
Connect the red pin (R) on the KY-016 to pin 11 on the Arduino. Blue (B) to pin 10, green (G) to pin 9 and ground (-) to GND. Notice that you do not need to use limiting resistors since they are already included on the board.
Connection Diagram:
Â
Pin Connection with Arduino:
LED module | Arduino |
R | Pin 11 |
B | Pin 10 |
G | Pin 9 |
– | GND |
Â
Features :
- The use of plug-in full-colour LED.
- RGB trichromatic limiting resistor to prevent burnout.
- With a variety of single-chip interface.
- Through the PWM adjusting, three primary colours can be mixed to obtain different colours
- The working voltage: 5V
Package Includes :
1 x DIP 3 Color LED Module.
sunnyjaiswaldelhi (verified owner) –
Good, can be directly connected to Raspberry Pi. But its expensive
sunnyjaiswaldelhi –