This is a dual Gigabit ethernet 5G/4G baseboard, which is designed for Raspberry Pi Compute Module 4. It is suitable for evaluating the Raspberry Pi CM4 or being integrated into end products.
Whats on Board:
- CM4 socket: suitable for all variants of Compute Module 4
- 40PIN GPIO header: for connecting sorts of HATs
- RJ45 Gigabit Ethernet
dual RJ45 Gigabit Ethernet, 10/100/1000M compatible
ETHERNET 0: CM4 original ETH
ETHERNET 1: USB extended ETH - USB 3.2 ports: 3x USB 3.2 Gen1, for connecting sorts of USB devices
- HDMI connectors: 2x HDMI, supports 4K 30fps output
- CAM: 2x MIPI CSI camera ports
- DC power supply: 7~36V DC wide voltage range power input
- Dual LED indicators
red: Raspberry Pi power indicator
green: Raspberry Pi operating status indicator - Micro SD card slot: for connecting a Micro SD card with pre-burnt image (Lite variant ONLY)
- FAN header: for connecting cooling fan, allows speed adjustment and measurement
- DISP0
MIPI DSI display port - USB SLAVE port:for burning system image into Compute Module 4 eMMC variants
- RTC battery holder: supports CR1220 button cell
- RTC interruption configuration
PI-RUN: CM4 will reboot on RTC interruption
GN-EN: CM4 power-down on RTC interruption
D4: D4 pin is triggered on RTC interruption - IO-VREF selection:set the CM4 IO logic level as 3.3V or 1.8V
- FAN power supply selection:select 5V or 12V power to drive the fan
- System function configuration
BT_DIS: Bluetooth disabled, for CM4 with antenna variant ONLY
WiFi_DIS: WiFi disabled, for CM4 with antenna variant ONLY
WP_DIS: boot mode switch, ONLY be used when NOT booted from eMMC or SD card - RTC/FAN I2C bus selection
SDA0/SCL0: I2C-10 is shared with CSI/DSI
GPIO3/2: I2C-1 is shared with 40PIN header - RTL8153:USB Gigabit Ethernet chip
- EMC2301:fan controller allows fan speed adjustment and measurement
- VL805:USB 3.0 HUB
Specification:
- Cm4 socket suitable for all variants of computing module 4
- Networking dual gigabit ethernet rj45
- M.2 b key, for connecting 5g / 4g module
- Nano-sim card slot supports standard nano-sim card for 5g/4g/3g/2g communication
- USB USB 3.2 gen1 × 2
- Pin header raspberry pi 40pin pin header
- Display mipi dsi port (15pin 1.0mm FPC connector)
- Camera mipi csi-2 port × 2 (15pin 1.0mm fpc connector)
- Video hdmi × 2, supports 4k 30fps output
- Rtc real-time clock with a battery socket and ability to wake to compute module 4
- Storage MicroSD card socket for compute module 4 lite (without emmc) variants
- Fan header 5v/12v (12v by default), allows speed adjustment and measurement
- Power input 5v/2.5a
- Dimensions 99.6 × 87.0mm
Package Includes:
1 x Waveshare Dual Gigabit Ethernet 5G/4G Base Board
There are no reviews yet.