Generic
Showing 961–1008 of 6083 results
-
Temperature & Humidity Sensor
3 Pin NTC Thermistor Temperature Sensor Module
SKU: 365937- Adopt the NTC thermistor sensor, sensitivity is good
- The comparator output, signal clean, good waveform, driving ability is strong, for more than 15 ma.
- With potentiometer to adjust the temperature detection threshold
- Working voltage: 3.3 V to 5 V
- Output form: digital switch output (0 and 1)
- It has a fixed bolt hole, convenient installation
SKU: 365937 -
-
TowerPro and Other Servo Motors
TowerPro MG945 Digital High Speed Servo Motor – Standard Quality
SKU: 618526- Stall torque: 10kg/cm (4.8v); 12kg/cm (6v)
- Operating voltage: 4.8 ~ 6.6v
- Temperature range: 0- 55deg
- Gear Type: Metal gear
- Dead band width: 1us
- servo wire length: 32cm
- Servo Plug: JR (Fits JR and Futaba)
SKU: 618526 -
-
RGB LED Strips and Drivers
250W High Power Constant voltage Current Adjustable Aluminum Substrate LED Driver Module
RGB LED Strips and Drivers250W High Power Constant voltage Current Adjustable Aluminum Substrate LED Driver Module
SKU: 405563- DIY a stabilized power supply, input 12V is ok, the output can be adjustable in the range of 12~50V.
- Offer power for your electronic equipment, you can set the output voltage value according to your system voltage.
- As the car power supply offer power for your laptop, PDA or a variety of digital products.
- A high-power notebook mobile power DIY: coupled with a large-capacity 12V lithium battery pack
- Solar panel voltage regulator.
- Charge for the storage battery, lithium battery etc.
- Â Drive high-power LED lights.
SKU: 405563 -
-
DIY Hobby Project Parts
10Pin Alligator Clips Jumper Wires Crocodile Dupont Line with Female Connector Cable for DIY Connection – 20cm
DIY Hobby Project Parts10Pin Alligator Clips Jumper Wires Crocodile Dupont Line with Female Connector Cable for DIY Connection – 20cm
SKU: 1017145- Colour: Red, Blue, Yellow, White and Black.
- Cable Length: 20 cm
- Connector Type: Crocodile Pins and Female Dupont Connector
- Color-coded insulated leads allow you to test circuits without crossing wires or causing shorts with each other.
SKU: 1017145 -
Raspberry Pi Case
Acrylic Case for Raspberry PI 4 Model B
SKU: 518840- 6-piece Acrylic case with access to all Ports on pi 4
- Compatible for All varient of the Raspberry pi 4 Model B
- Easy to assemble without any Screws or Nut-Bolts
- Slots to route GPIO and CSI ribbon cable
- Cut-out for micro SC card at the bottom panel
- Mounting holes and anti-slip rubber feet at the back.
SKU: 518840 -
Raspberry Pi Accessories
HDMI Female to HDMI Male Right, Angle Adapter for Raspberry Pi 3
SKU: 1121311- Supports resolutions up to 4Kx2K (UHD) including 4096×2160, 3840×2160, 2560×1600, 2560×1440, 1920×1200 & 1080p
- HDMI Male-Female Adapter Right Angle 90 Degree
- Gold Plated HDMI Male to Female Connector Supports 4K for TV Stick
SKU: 1121311 -
Cooling Fans
DC 24V 5015 Hydraulic Centrifugal Fan with XH2.54-2P 30CM Cable Size:50*50*15MM
SKU: 1187539- 45mm Radial Cooling fan.
- 24V 2-point Pin DC
- Made of high-quality PBT 30% glass line VO
- Bearing is a high precision, long life, and low noise.
- Excellent for cooling heat sinks on hot ends, prints, or other cooling needs
SKU: 1187539 -
Lipo Voltage Checker
Cell Checker with Low Voltage Alarm (2S-8S) with case
SKU: 4091- Input: 2S-8S Battery
- Battery type: Lipo/LiFe/Li-ion/LiMn
- It has a Buzzer Alarm for low voltage indication.
- Useful for measuring each cell voltage.
- Cell Voltage Display Range: 0.5v-4.5v
- Total Voltage Display Range: 3.7-36v
- Alarm set values: Off or 2.7-3.8v
SKU: 4091 -
Other Metal Geared Motors
10RPM 12V Low Noise DC Motor With Metal Gears – Grade A
SKU: 1137797- The metal gears have better wear and tear properties.
- Gearbox is sealed and lubricated with lithium grease and requires no maintenance.
- Although motor gives 10 RPM at 12V, motor runs smoothly from 4V to 12V and gives the wide range of RPM, and torque.
- The shaft has a hole for better coupling.
- Operating Voltage(V): 12
- Rated Torque(kg-cm): 7
- Stall Torque(kg-cm): 28
SKU: 1137797 -
Spacer and Standoff
M4 X 5 mm Female to Female Brass Hex Threaded Pillar Standoff Spacer – 12 Pcs.
SKU: 878515- Versatile and easy to fit.
- Lock PCB securely into place.
- Hexagonal design allows tightening with a wrench.
- The brass metal itself provides good resistance to oxidation and corrosion.
SKU: 878515 -
-
Other Metal Geared Motors
150RPM 12V Low Noise Dc Motor With Metal Gears – Grade A
SKU: 1137798- The metal gears have better wear and tear properties.
- The gearbox is sealed and lubricated with lithium grease and requires no maintenance.
- Although the motor gives 150 RPM at 12V, the motor runs smoothly from 4V to 12V and gives a wide range of RPM, and torque.
- The shaft has a hole for better coupling.
- Operating Voltage(V): 12
- Rated Torque(kg-cm): 2
- Stall Torque(kg-cm): 7.8
SKU: 1137798 -
Sleeves and Drag Chain
Nylon 25mm Expandable Braided Sleeve for Wire Protection-2M Length
SKU: 457748- Great for wrapping power/ground cable.
- Protect cables from wear & high temperature.
- Prolong the service life of the cable.
- Very easy to bend.
- Ultra expandable (150% of original size).
- Gives an attractive look with a clean install.
- Application: Bundle Wiring of Moving Assembles
SKU: 457748 -
Relay Modules
5V 8 Channel Relay Module
SKU: 618461- The 8550 transistor drive, driveability.
- A fixed bolt holes for easy installation.
- It has a relay status indicator led Power LED(Green), 8 relay status indicator LED(Red)
- Relay control interface by single-chip IO.
- Low-level suction close, high-level release.
- Easy to use, simple 3 line structure.
SKU: 618461 -
-
-
-
-
-
-
