Generic
Showing 1537–1584 of 6091 results
-
-
-
-
-
Compatible with Arduino Boards
MCP2515 Can Bus Shield Board SPI Interface 9 Pins Standard Sub-D Connector Expansion Module
Compatible with Arduino BoardsMCP2515 Can Bus Shield Board SPI Interface 9 Pins Standard Sub-D Connector Expansion Module
SKU: 790468- SPI Interface up to 10 MHz.
- Implements CAN V1.2 B at up to 1 Mb/s.
- Arduino/ Freaduino Completely compatible.
- Industrial standard 9 pin sub-D connector.
- Standard (11 bit) and extended (29 bit) data and remote frames.
SKU: 790468 -
Carbon Fiber Tubes and Rods
3K Roll-wrapped Carbon Fibre Tube (Hollow) 14mm(OD) * 12mm(ID) * 1000mm(L)
Carbon Fiber Tubes and Rods3K Roll-wrapped Carbon Fibre Tube (Hollow) 14mm(OD) * 12mm(ID) * 1000mm(L)
SKU: 653499- Made of Carbon Fiber material
- High Strength
- Stable dimension and UV resistant
- High Corrosion Resistance
- High Thermal Conductivity in some forms
- Low coefficient of thermal expansion
- Non-poisonous
SKU: 653499 -
-
-
Drone Motor
Set of 4 A2212 1400KV Brushless Motor for Drone with SimonK 30A ESC and Orange 1045 Propeller Set
Drone MotorSet of 4 A2212 1400KV Brushless Motor for Drone with SimonK 30A ESC and Orange 1045 Propeller Set
SKU: 5931- Offers great performance and value for money.
- Comes in the compact sizes.
- Suitable for airplane, aircraft, quadcopter.
- ESC used has an On-Board BEC.
- Faster and Better speed control.
SKU: 5931 -
Relay Modules
2 Channel Relay Module, 30A with Optocoupler, Isolation 12V Supports, High and Low Triger
Relay Modules2 Channel Relay Module, 30A with Optocoupler, Isolation 12V Supports, High and Low Triger
SKU: 1121231- Supply Voltage: DC 12V
- Quiescent Current: 5mA
- Maximum Operating Current: 190mA
- Trigger Mode: High and low-level trigger
- Load Voltage: DC 30V / AC 250
- Load Current: 30A
- Relay Life: more than 100,000 times
SKU: 1121231 -
Smart Vision Cameras
1600X 3 in 1 USB Digital Microscope Camera Endoscope 8LED Magnifier with Stand 3-in-1 Type-c Electronic Magnifier Endoscope
Smart Vision Cameras1600X 3 in 1 USB Digital Microscope Camera Endoscope 8LED Magnifier with Stand 3-in-1 Type-c Electronic Magnifier Endoscope
SKU: 1150650- Specification: Magnification: 1600X
- Light source: 8 LED lights
- Resolution: 1920×1080, 640*480
- Pixel: 30W
- Focal length: 3-40mm manual adjustment
- Support Android 4.2 or above/widows/Mac system
SKU: 1150650 -
Environmental Sensors
Wind Speed Sensor Current Type(4 to 20mA) Anemometer Kit (Waterproof & Industrial)
Environmental SensorsWind Speed Sensor Current Type(4 to 20mA) Anemometer Kit (Waterproof & Industrial)
SKU: 949449- The mode of its output signal:4 to 20mA
- supply voltage: DC 12-24V.
- Power consumption: MAX≤0.3W.
- Start wind speed：0.4-0.8m/s.
- Effective measurement range:0-30m/s
- Transmission distance (m):< 1000 m
SKU: 949449 -
-
Emax Servo Motor
EMAX ES9251 II 4.5V-6V Plastic Micro Digital Servo 2.5gm for RC Models
SKU: 596521- Operating Voltage: 4.5~6.0V
- STD Direction: Counter Clockwise / Pulse Traveling 1500 to 1900usec
- Stall Torque: 4.8V 0.3 Kgf.cm
- Operating Speed: 4.8V 0.08 Sec/60° at no load
- Type: Digital
- Material: Plastic
SKU: 596521 -
-
-
Digital Voltage, Current and Frequency Meter
Dual Led 0.28″ Display for DC0-100V 50A Voltage and Current Test Digital Instrument, Digital Meter Panel Amplifier Red Blue 50A
Digital Voltage, Current and Frequency MeterDual Led 0.28″ Display for DC0-100V 50A Voltage and Current Test Digital Instrument, Digital Meter Panel Amplifier Red Blue 50A
SKU: 1187602- Operating current: 10mA
- Operating voltage: DC 4.5 ~ 30V
- Minimum resolution(V): 0.1V
- Minimum resolution(A): 0.01A
- Display color: Red and Blue (two-color display)
- Measure accuracy: 1%
SKU: 1187602 -
3D Printer Nozzle
M6 Thread Brass Nozzle V5 V6 UM Compatible – 3mm x 0.2mm (for 3D printer)
SKU: 293809Modify your 3D printer to print fine details or large parts with V6 M6 Thread Brass Nozzle range at robu.in. These nozzles are fully integrated into the ecosystem of 3D printer parts and are compatible with V6, Lite6, and Titan Aero. Compatible with Prusa 3D printers.
SKU: 293809 -
-
Other ESP WIFI Modules
RTL8188 Mini USB wireless Network Card 150Mbps Wi-Fi Dongle
SKU: 1326850- RTL8188cus Chipset
- Mini portable USB 2.0 design.
- Wireless N speed up to 150Mbps, ideal for internet surfing and online gaming.
- Complies with IEEE 802.11n (Draft 2.0), IEEE 802.11g, IEEE 802.11b standards.
- MIMO technology makes wireless transmission rates up to 600Mbps wifi antenna.
- 600Mbps Wireless Wifi USB Dongle/Wireless USB Adapter/Wireless Network Card
SKU: 1326850 -
-
-
N20 Metal Gear Motors
N20-3V-200 RPM Micro Metal Gear-box DC Motor
SKU: 475212- This is a DC Mini Metal Gear Motor, ideal for making robots.
- Lightweight, high torque and low RPM.
- Fine craftsmanship, durable, not easy to wear.
- With excellent stall characteristics, can climb hills easily.
- You can also easily mount a wheel on the motor’s output shaft.
SKU: 475212 -
