PM02D provides regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6pin cable. The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 12S (HV). The Power Module comes completely assembled with XT60 connectors, wrapped in shrink tubing for physical damage protection.
It is not designed to power servos, please use your aircraft’s ESC/BEC for that. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact.
Note:
PM02D HV version is supported by PX4. For Ardupilot, it is supported in version 4.4 and later. Full setup guide can be found here.
This PM uses I2C digital signal data output, Compatible with Pixhawk 5X/6X Series.
NOT compatible with flight controller that uses analog PM such as the Pixhawk 6C & Mini, Pixhawk4 & Mini, pix32 v5, or Durandal flight controllers.
Specifications:
Max input voltage: 36V
Rated current: 60A
Max current: 120A (<60S)
Max current sensing: 164A
Supports up to 6S battery
Voltage and current monitor with I2C compatible interface
Switching regulator outputs 5.2V and 3A max
Weight: 20g
Current Rating: The PM02D comes with XT60 plugs with 14 AWG silicone wires rated for 30A continuous current and 60A burst current (<1 minute).
Features:
- Regulated Output: 5.2V and 3A max for stable power supply
- Battery Compatibility: Supports LiPo batteries up to 12S (HV)
- Current Sensing: High-accuracy current sensing up to 327A for HV
- Monitoring Interface: I2C compatible interface for voltage and current monitoring
- Physical Protection: Wrapped in shrink tubing to prevent damage
- Connectors: Equipped with XT60 connectors for reliable connections
Package Includes:
1 x Holybro PM02D Power Module High Voltage (2S -12S)
There are no reviews yet.