Generic
Showing 2881–2928 of 6083 results
-
Buck Converter
7A DC 60V Adjustable Step-Down Regulator NC Power Supply Module Current Voltage Meter LCD Display(With Case)
Buck Converter7A DC 60V Adjustable Step-Down Regulator NC Power Supply Module Current Voltage Meter LCD Display(With Case)
SKU: 1121269- Output Voltage: 3~32V adjustable (It can save the last set voltage automatically)
- Peak Current: Recommended use in 2A, the accuracy of 1%, the minimum display 0.01A, less than 10mA will not be displayed.
- Peak Current: 3A (Recommended use in 2A, the accuracy of 1%, the minimum display 0.01A, less than 10mA will not be displayed.)
- Conversion Efficiency: 95%
- Load Regulation S(I) 0.8%
- Voltage Regulation S(U) 0.8%
- Size: 62 x 44 x 18mm
- Weight: 45g
SKU: 1121269 -
-
-
-
-
-
-
-
-
-
-
-
Audio Amplifier Module
2x6W DC 5V 3.7V speaker modified Stereo Bluetooth amplifier board can connected lithium battery
Audio Amplifier Module2x6W DC 5V 3.7V speaker modified Stereo Bluetooth amplifier board can connected lithium battery
SKU: 1150679- Item Type: Amplifier Board
- Model: HF69B
- Supply Voltage: 5VDC or 3.7V lithium battery
- Applicable Speaker Impedance: 4 ohms, 6 ohms, 8 ohms
- Charging Interface: When using a lithium battery, the charging interface can be charged with a 5 volt power supply or a mobile phone charger to charge a single lithium battery.
SKU: 1150679 -
IoT WIFI Smart Switches
DC5-32V 4CH WiFi RF, Switch Module Intelligent, Timing Switch Remote, Control
IoT WIFI Smart SwitchesDC5-32V 4CH WiFi RF, Switch Module Intelligent, Timing Switch Remote, Control
SKU: 1121285- Operating Voltage: 5-32V
- Control Mode: 433 Remote Control
- Mode of transport: Wifi
- Remote control frequency: 433 MHZ
- Wifi Work Frequency: 2.4G 802.11 b / g / n
- Power Power Consumption of Rest: 80mA; if all relays are up, max 380mA
SKU: 1121285 -
Temperature & Humidity Sensor
Digital Temperature Module For Arduino AVR PIC DIY Maker
SKU: 699535- Power supply: 3 – 5V
- Good sensitivity
- The output format: Digital switching output (0 and 1)
- The comparator output signal is clean, good waveform, driving ability, more than 15mA.
- A fixed bolt holes for easy installation.
- Using a wide voltage LM393 comparator.
Â
Â
SKU: 699535 -
-
-
Raspberry Pi Accessories
2-IN-1 Raspberry Pi Dual TF / SD Card Switcher Adapter
SKU: 210649This 2-IN-1 Raspberry Pi Dual TF / SD Card Switcher Adapter is a micro SD card switcher, specially designed for the Raspberry Pi to serve the purpose. You can now enjoy the convenience of using two micro SD cards at the same time on the same Pi!
SKU: 210649 -
Flight Controller & Accessories
Micro Minim OSD For Racing F3 Naze32 Flight Controller RC Drone
SKU: 29457- ATmega328P with Arduino bootloader.
- MAX7456 monochrome on-screen display.
- +5V 500mA regulator for up to +12V supply input.
- FTDI cable compatible pinout.
- The standard 6-pin ISP header.
- Standalone, or with APM/ Flip / Flip32+ flight controllers.
SKU: 29457 -
-
-
-
