Flight Controller & Accessories
Showing 97–144 of 165 results
-
Flight Controller & Accessories
Holybro Tekko32 F4 4in1 Mini 50A ESC
SKU: 1777636- Model: Holybro Tekko32 F4 4in1 Mini 50A ESC
- Dimensions: 32 x 40 mm
- Supports DShot 150/300/600/1200/2400.
- Compatible with MultiShot, OneShot, Proshot, PWM, etc.
- ESC telemetry supported for enhanced monitoring.
SKU: 1777636 -
Flight Controller & Accessories
SpeedyBee F405 Mini BLS 35A 20×20 Stack
SKU: R100760- MCU STM32F405
- IMU(Gyro) ICM42688P
- USB Port type Type-C
- Barometer Built-in OSD Chip AT7456E chip
- Power Input 3-6S LiPo.
- The flight controller is powered through the G, V wires of the 8pin harness or G, V pads from the bottom side of the flight controller.
SKU: R100760 -
Flight Controller & Accessories
DJI Naza M Lite Multi-Rotor Flight Controller without GPS
SKU: 29615- Input Voltage (V): MC: 4.8V~5.5V (recommended 2S~6S Lipoly).
- Power Consumption: MAX: 1.5W (0.3A @ 5V), Normal: 0.6W (0.12A @ 5V).
- Operating Temperature:-10°C ~ +50°C.
- Supported ESC Output: 400Hz refresh frequency
SKU: 29615 -
Flight Controller & Accessories
Holybro Digital Air Speed Sensor(MS5525DSO) With PT40 Pivot Tube
SKU: R110848- Integrated Digital Pressure Sensor(24-bit ∆Σ ADC)
- Fast Conversion Down to 1 ms
- Low Power, 1 µA (standby < 0.15 µA)
- Supply Voltage: 1.8 to 3.6V
- Pressure Range: 1 to 30 PSI
- I2C and SPI Interface
SKU: R110848 -
Flight Controller & Accessories
EMAX Mini Magnum 2 F4 35A Flytower 20x20mm 35A 2-6S BLHeli_32 4in1 ESC+F4 Flight Controller OSD+VTX
Flight Controller & AccessoriesEMAX Mini Magnum 2 F4 35A Flytower 20x20mm 35A 2-6S BLHeli_32 4in1 ESC+F4 Flight Controller OSD+VTX
SKU: 812603- Stack Size: 20x20mm
- Flight Controller: F4 Flight Controller (OMNIBUSF4 Firmware)
- ESC: 4in1 BLHeli_32 35A ESC
- Supply Voltage: 2-6S lipo
- VTX: 25mW/200mW
SKU: 812603 -
-
-
Flight Controller & Accessories
Holybro PM08 Power Module (14S, 200A)
SKU: 1777629- Model: Holybro PM08 Power Module (14S, 200A)
- Support 2S – 14S Battery
- 200A Cont. Current Rating
- Easy to Setup
- Aluminum Case for Heat dissipation
- Dimensions: 101*45*26mm
- Mounting hole: 79mm*38.1mm
- Weight: 151g
SKU: 1777629 -
-
Flight Controller & Accessories
Holybro Kakute H7 V2 Flight Controller
SKU: 1429630- MCU STM32H743 32-bit processor running at 480 MHz
- VTX ON/OFF Pit Switch – Switch can be enabled using USER1 in the Beta flight Mode tab.
- H7 processor @480 MHz
- Bluetooth onboard
- 8 Motors outputs in plugs
- 128 MB flash for logging
- VTX On/Off switch
SKU: 1429630 -
Flight Controller & Accessories
Holybro Digital Air Speed Sensor(MS5525DSO) With PT60 Pivot Tube
SKU: R110849- Integrated Digital Pressure Sensor(24-bit ∆Σ ADC)
- Fast Conversion Down to 1 ms
- Low Power, 1 µA (standby < 0.15 µA)
- Supply Voltage: 1.8 to 3.6V
- Pressure Range: 1 to 30 PSI
- I2C and SPI Interface
SKU: R110849 -
Flight Controller & Accessories
T Motor MINI F45A 6S 4IN1
SKU: 1800267- Mini body strong performance.
- Reliable & High-Quality MOSFET.
- Safeguard electronic components from vibration impact.
- Input Voltage: 3- 65
- ESC Firmware: BLHeli32
- Telemetry: Support
- galvanometer: Support
- Mounting pitch: 20 x 20mm
- Weight: 9.2g
- beta flight galvanometer ratio: 200
SKU: 1800267 -
Flight Controller & Accessories
Holybro Tekko32 F4 Metal 4in1 65A ESC (65A)
SKU: 1777637- Model: Holybro Tekko32 F4 Metal 4in1 65A ESC (65A)
- Metal-cased MOSFET
- Smooth control and quick response
- Supports DShot 150/300/600/1200 & MultiShot/OneShot/Proshot/PWM etc.
- ESC telemetry Supported
- Onboard analog current sensor
- BLHeli_32 firmware
SKU: 1777637 -
-
Flight Controller & Accessories
Pixhawk 2.4.8 Drone Flight Controller PX4 32 Bit Autopilot – Good Quality
Flight Controller & AccessoriesPixhawk 2.4.8 Drone Flight Controller PX4 32 Bit Autopilot – Good Quality
SKU: 29453- Supply Voltage: 7V.
- Processor: 32 Bit Cortex M4 Core
- Bus interface (UART, I2C, SPI, CAN).
- Firmware: Mission planner.
- Sensors: Gyrometer, Accelerometer, Barometer & Magnetometer
- Micro SD card to record flight data.
SKU: 29453 -
Flight Controller & Accessories
Holybro Kakute F4 V2.4 Stacks + Tekko32 F4 4in1 50A ESC
SKU: 1777617- Model: Holybro Kakute F4 V2.4 Stacks + Tekko32 F4 4in1 50A ESC
- New and faster F4 MCU @ 150Mhz (compared to F3 @108Mhz & F0 @48Mhz)
- PWM Frequency: 16k to 96k
- 1000uf 35v capacitor included (highly recommended for 6s setup)
- Amperage meter scale ratio: 120 (V1.9 Version)
SKU: 1777617 -
-
Flight Controller & Accessories
DJI NAZA-M Lite V1.1 with GPS Kit
SKU: 56686- Supported Multi-Rotor: Quad-rotor I4, X4 / Hex-rotor I6, X6, IY6, Y6.
- Supported ESC Output: 400Hz refresh frequency.
- Recommended Transmitter: PCM or 2.4GHz with minimum 4 channels.
- Power Consumption: MAX1. 5W (0.3A@5V) Normal:0.6W (0.12A@5V).
- Weight: MC:25g; VU:20g; GPS:21.3g.
- All-in-One Design.
- Advanced attitude stabilized Algorithm.
- Multiple flight control mode/intelligent switching.
- GPS Module Available/Accurate Position hold.
- Intelligent Orientation Control (IOC).
- Failsafe mode.
SKU: 56686 -
Flight Controller & Accessories
Holybro Kakute H743 Wing Flight Controller with Micro M10 GPS Module
SKU: 1720323- MCU: STM32H743, 480 MHz, 1MB RAM, 2MB Flash
- IMU: ICM-42688P (SPI3)
- Baro: BMP280 (I2C4)
- OSD: AT7456E (SPI2)
- Blackbox: MicroSD card slot on SDMMC2
- 7x Uarts (1,2,3,5,6,7,8) with built-in inversion.
SKU: 1720323 -
Flight Controller & Accessories
Holybro Kakute F4 V2.4 Stacks + Tekko32 F4 Metal 4in1 65A ESC
SKU: 1777620- Model: Holybro Kakute F4 V2.4 Stacks + Tekko32 F4 Metal 4in1 65A ESC
- Fast F4 MCU: operating at 150MHz.
- PWM Frequency Range: Supports PWM frequencies ranging from 16k to 96k.
- Metal-Cased MOSFET: metal-cased MOSFET for efficient heat dissipation.
- On-Board Capacitance: on-board capacitance at 2068uF for effective noise filtering, enhancing signal quality.
- 3 oz Copper PCB Design
- Separate Drive & Control Circuit
SKU: 1777620 -
Flight Controller & Accessories
CUAV CAN PDB Multifunctional Autopilot Baseboard
SKU: 1504849- Support 10~62V ultra-wide voltage input
- Continuous current: 180A
- Accurately measure voltage and current, current accuracy within 110A is 0.1A, voltage accuracy is 0.05V
- 14 servo channel output
- Dual regulated output interface: It can provide up to 5V/6A, 12V/4A power output for peripherals
- Ultra-thick copper and thick tin-plated PCB can effectively reduce the heating caused by the internal resistance of the circuit under high current.
SKU: 1504849 -
-
-
Flight Controller & Accessories
DJI NAZA M V2 Multirotor Autopilot Controller set with GPS
SKU: 45468- Input Voltage (V): MC: 4.8V~5.5V (recommended 2S~6S Lipoly).
- Supported ESC Output 400 Hz refresh frequency
- Supported Transmitters PCM or 2.4 GHz radio with at least 4 channels
- Power Consumption MAX: 1.5 W (0.3 A at 5 V)
- Operating Temperature: -10 to 50°C
SKU: 45468 -
Flight Controller & Accessories
Holybro kakute F7 & amp- tekko 32 Blheli32 4 in 1 ESC stack
SKU: 1010945- Supports 3-6S Lipo input
- 35A continuous current, 50A burst
- MCU: STM32F745 32-bit processor
- IMU: ICM20689 (SPI)
- Barometer: BMP280
- Current Sensor: Approximately 130 amps maximum measurable value
- Supports Betaflight, Butterflight, and Cleanflight.
SKU: 1010945 -
Flight Controller & Accessories
AeroFC Flight Controller Board
SKU: 821127- High-Speed STM32 processor
- Triple Redundant IMU
- Light Weight
- Isolated & Dampened IMU
- Compatible with Ardupilot and PX4.
- It can be configured with AeroGCS, Mission Planner, QGround Control software, etc.
Limited Time Launch Offer !!!
SKU: 821127 -
Flight Controller & Accessories
Holybro Pix32 V6 FC Module Only
SKU: 1812213- High-performance STM32H743 Processor with more computing power & RAM
- New cost-effective design with the low-profile form factor
- A newly designed integrated vibration isolation system to filter out high-frequency vibration and reduce noise to ensure accurate readings
- IMUs are temperature-controlled by onboard heating resistors, allowing the optimum working temperature of IMUs
SKU: 1812213 -
Flight Controller & Accessories
 Pixhawk 6C (plastic case)
SKU: R100011- Advanced flight controller with PX4 Autopilot.
- STM32H743 processor up to 480 MHz for efficient processing.
- Redundant IMUs for reliability from Bosch & InvenSense.
- An integrated vibration isolation system ensures accurate readings.
- Suitable for academic, commercial, and research applications.
- Cost-effective design with high performance.
SKU: R100011 -
Flight Controller & Accessories
Holybro Pix32 v6 Flight Controllers FC Module Standard Set
SKU: 1444801- High-performance STM32H743 Processor with more computing power & RAM
- New cost-effective design with the low-profile form factor
- A newly designed integrated vibration isolation system to filter out high-frequency vibration and reduce noise to ensure accurate readings
- IMUs are temperature-controlled by onboard heating resistors, allowing the optimum working temperature of IMUs
SKU: 1444801 -
Flight Controller & Accessories
CUAV V6X Flight Controller
SKU: 1590285- H7 Double-precision floating-point processor
- High-performance ARM M3 coprocessor
- Low-noise Car-grade IMUs
- Triple redundant IMUs and dual redundant barometer designs
- Car-grade RM3100 magnetic compass
- New built-in shock absorption design
SKU: 1590285