Generic
Showing 1345–1392 of 6100 results
-
-
-
6S Li-ion BMS
6S 40A 18650 Lithium Battery Protection Board
SKU: 618355- Maximum discharge current: 40A
- Instantaneous discharge current: 70A
- Charging voltage: 25.5V
- Maximum charging current: 40A
- Overcharge detection voltage: 4.25±0.025V
- Overcharge protection delay: 1.0±0.5S
- Overcharge release voltage: 4.15±0.05V
- Battery balance detection voltage: 4.125±0.025V
- Battery balance release voltage: 4.125±0.05V
- Battery balance current: 41±5mA
- Working current: ≤40uA
SKU: 618355 -
-
Light/color Sensor
Photosensitive Resistor Sensor Module for Arduino
SKU: 766370- This is a High-quality photosensitive sensor module/light module detects the photosensitive resistor for Arduino
- Resistance of the photoresistor is typically less than 80 Ohms (in full light)
- Dark resistance is typically greater than 20 Meg Ohms (in full darkness)
SKU: 766370 -
-
3D Printer Extruder Parts and Fans
PC6-M10 Pneumatic Push in Bowden Extruder for 6mm tube J-Head fitting
3D Printer Extruder Parts and FansPC6-M10 Pneumatic Push in Bowden Extruder for 6mm tube J-Head fitting
SKU: 288374- Inside Diameter: 6mm
- Thread Size: M10
- PTFE Tubing Compatibility: 3mm ID PTFE Tubing (for 1.75mm Filament)
- Materials:Â Nickel Plated Brass
- Release Method:Â Elliptical John Guest Fitting
SKU: 288374 -
RC Car Wheel
65mm Robot Smart Car Wheel for BO Motors (Green)
SKU: 668614- Tire with sponge liner for more strength
- With upgraded tire tread for greater friction
- New design wheel for better combination with the motor
- Diameter: 65 mm
- Width : 28 mm
- The material of Wheel: High-strength plastic
- The material of Tyre: Rubber
- Color: Green
SKU: 668614 -
-
-
-
Other Sensors
PAJ7620 Gesture Recognition Sensor
SKU: 860807- The supply voltage is 2.8V- 3.3V and I/O voltage is 1.8V~3.3V
- Nine gesture recognition (Up / Down / Left / Right / Push / Pull / CW / CCW / Wave)
- Gesture speed is 60°/s to 600°/s in Normal Mode and 60°/s to 1200°/s in Gaming Mode
- Ambient light immunity: < 100k Lux
SKU: 860807 -
-
-
Current and Voltage Sensor
5A 12V Overcurrent Protection AC Current Detection Sensor Module
SKU: 400224LC 5A Over-current protection Sensor module uses a current transformer to collect the AC signal to achieve the relay over-current signal output within 0-5A. Relay pull while over-current, relay released while not over-current
SKU: 400224 -
12V Li-Ion Battery (11.1V~12.6V)
Orange INR 18650 11.1V 2000mAh 3C 3S1P Li-Ion Battery Pack
SKU: 514618- Maximum Output Voltage: 12.6 VDC.
- High energy density.
- Charge connector: JST-XH connector
- Discharge connector: Nylon Female T Connector
- Good consistency and low self-discharge.
- Long life with full capacity for up to 500 charge cycles.
- Inbuilt (BMS) battery protection circuit.
SKU: 514618