Generic
Showing 97–144 of 6087 results
-
Other ESP WIFI Modules
ESP8266 Adapter Plate Serial Wireless WIFI Module-1pcs
SKU: 31233- It features reserved land-pattern for the 3.3V regulator
- It has Pinouts on the top layer in black colour.
- Compatible with Latest ESP-12F ESP8266 Wifi Module
- It includes a 10K pull-up resistor populated on PCB.
SKU: 31233 -
FFC, FPC, Berg connectors
1×40 Berg Strip Male Connector – 10pcs
SKU: 470829- Number of Pins: 40
- Pin Spacing(pitch): 2.54 mm
- Length of the Strip: 103 mm
- Pin height: 6 mm
- Square Posts.
- Stackable – End to End and Side to side.
- Can be manually broken for the length needed.
- Standoffs allow cleaning of solder contaminants.
SKU: 470829 -
Brushed / Brushless DC motor Driver
12V-40V10A DC Motor PWM Speed Control Switch Governor
SKU: 699487Input supply voltage: DC 12V-40V
The maximum output power: 400W
The maximum continuous output current:8A
Static Current:0.02 A ( Standby )
PWM frequency: 13kHz
Duty Cycle adjustable: 10%-100%SKU: 699487 -
-
-
Best Prices, Temperature & Humidity Sensor
DHT11 Temperature And Humidity Sensor Module with LED
-32%
Best Prices, Temperature & Humidity SensorDHT11 Temperature And Humidity Sensor Module with LED
SKU: 618487- Input Supply voltage (VDC): 3.3 ~ 5
- Supply Current (mA): measurement 0.3mA standby 60μA.
- Temperature measurement range: 0~50 degrees
- Temperature measurement error: ±2 degrees
- Humidity measurement range: 20%~95%RH
- Humidity measurement error: ±5%RH
SKU: 618487 -
-
Buck Converter
LM2596 HV DC-DC Buck Converter 4.5-40V to 3-35V Adjustable Step Down Module
SKU: 520422- Input voltage: 4.5-40V,
- Output voltage: (3-35V) continuously adjustable (recommended load debugging).
- Minimum pressure: 1.5V
- Output current: rated current 2A, 3A maximum
- Output Power: 15W maximum
SKU: 520422 -
3S Li-ion BMS, Best Prices
3 Series 20A 18650 Lithium Battery Protection Board 11.1V 12V 12.6V
SKU: 223558- 3S 11.1V 12.6V 20A 18650 lithium battery protection board (comes with recovery function-AUTO Recovery).
- Application: Nominal voltage of 3.6V, 3.7V lithium battery (including 18650.26650, a polymer lithium battery).
- Continuous discharge current (upper limit): 20A (if the cooling environment is not good, please reduce the load current use).
- Continuous charge current (upper limit): 20A.
- Suitable for the drills with starting current below 80A, power below 135W
SKU: 223558 -
-
-
Breadboard and Zero PCBs
Transparent 830 Points Solderless Breadboard
SKU: 618319- Mb102 Bread Board
- 830 Solder-less Points
- Ideal for Experimenting With Circuit Design In Labs
- Compatible with resistance, diodes, transistors, LED’s, Capacitors and other types of electronic components
- Colored coordinates for easy components placement.
- Accept a variety of wire sizes 20-29 AWG
SKU: 618319 -
Plastic Push Button Switch
Tactile Push Button Switch 6x6x5 (Pack of 10)
SKU: 618182- Ideal for Through-hole applications.
- Shaft Shape: Round
- Used in the fields of electronic products, household appliances and more.
-
This light touch switch is waterproof, prevent oil, anti-pollution, anti-static interference.
-
High precision mechanism design offers acute operation and long service life.
-
Compact and lightweight, easy to carry and dismantling.
-
Good electrical conductivity.
SKU: 618182 -
-
-
Best Prices, Current and Voltage Sensor
CJMCU-219 INA219 I2C Interface No Drift Bi-directional Current / Power Supply Monitoring Module
-54%
Best Prices, Current and Voltage SensorCJMCU-219 INA219 I2C Interface No Drift Bi-directional Current / Power Supply Monitoring Module
SKU: 421237- 0.1 ohm 1% 2W current sense resistor
- Up to +26V target voltage
- Up to ±3.2A current measurement, with ±0.8mA resolution
- Senses Bus Voltages from 0 to 26 V
- 2C- or SMBus-compatible interface. The
- Reports Current, Voltage, and Power.
SKU: 421237 -
-
DIY Hobby Project Parts
50cm Long Alligator Clips, Electrical DIY Test Leads 5pcs, for Micro:bit
SKU: 1121253- Colour: Red, Green, Yellow, White, and Black, etc.
- Cable length: 40 cm.
- Net weight: 50 gm.
- They are very useful for connecting components to wires.
- It is insulation covered clips connected to the wire from both ends.
SKU: 1121253 -
-
USB Interface Module
ELM327 OBD2 V2.1 Bluetooth Interface Auto Car Diagnostic Scanner
SKU: 223562Measures:
- Engine RPM
- Calculated Load Value
- Coolant Temperature
- Fuel System Status
- Vehicle Speed
- Short Term Fuel Trim
- Long Term Fuel Trim
- Intake Manifold Pressure
- Timing Advance
- Intake Air Temperature
- Air Flow Rate
- Absolute Throttle Position
- Oxygen sensor voltages/associated short term fuel trims
- Fuel System status
- Fuel Pressure
SKU: 223562 -
-
Raspberry Pi Accessories
Raspberry Pi 4 Aluminium Heat Sink – 4 Set ( Size: 14 x 14 x 6, 14 x 9 x4 & 2 7 x 7 x 6)
Raspberry Pi AccessoriesRaspberry Pi 4 Aluminium Heat Sink – 4 Set ( Size: 14 x 14 x 6, 14 x 9 x4 & 2 7 x 7 x 6)
SKU: 1688911- Reduces the risk of hardware failure due to overheating
- Low profile, will fit into most cases.
- Simple, Passive cooling. No need for noisy fans.
- Perfectly sized for the RPi’s CPU
SKU: 1688911 -
-
-
Breadboard and Zero PCBs
Solderless 400 pin breadboard – Normal Quality – Without Packing
SKU: 1270232- 400 tie points
- 2 Power lanes, Total 100 tie points in power lanes
- 1 Double strip, Total 300 tie points
- Perfect for Arduino shield prototyping and testing
- Plastic housing, metal contact clips
SKU: 1270232 -
-
3D Printer Extruder Parts and Fans
High Temperature NTC 100K Thermistor with 1 Meter Cable
SKU: 84428- Temperature range of use: – 30 ℃ ~ + 350 ℃.
- Dissipation power factor: ≥5 mW / ℃ (static in the air).
- Sensor Diameter: 3 mm
- Cable Length: 1 meter
- Max power rating: 45 mW.
- Hot time constant : ≤7 s(in the air)
- Temperature coefficient of resistance : – 2 ~ 5% / ℃
SKU: 84428 -
-
Best Prices, GSM and RF Antenna
15cm 3DBI GSM/GPRS/3G PCB Antenna with IPEX Connector
SKU: 975676- Name: 2G 3G IPEX antenna
- Connector type: ipx13
- Gain definition: 3dBi (Typical)
- Frequency band definition: 1710
2170MHz 800960 - Impedance definition: 50 ohm
- Total length: as shown in Figure
- Impedance 50 Ohm
SKU: 975676 -
PCB Adapter
TQFP32/44/64/80/100 to DIP PCB Board Converter Adapter-1Pcs.
SKU: 107149- High-quality PCB FR4 Grade with FPT Certified.
- QFP/TQFP/LQFP/FQFP 32/44/64/80/100Â pin switch over DIP double-sided pinboard
- Double-sided FR-4PCB, unique design makes the board compatible with more models of IC packages QFP
SKU: 107149 -
