Generic
Showing 2353–2400 of 6087 results
-
Linear Actuators
12V 300MM Stroke Length Linear Actuator 6000N 5mm/s
SKU: 890199- Permanent magnet DC motor drive: Voltage 12VDC
- Self Locking Force: 6000N
- Working temperature: -20ºC to +80ºC
- Aluminium frame and extension tube
- Compact Design
- Built-in Limit Switch
- Low Noise
- Moisture-proof Surface
- Long life: The drive motor adopts a new carbon brush structure, with a service life of more than 50000 times.
SKU: 890199 -
Temperature & Humidity Sensor
DHT11 Temperature And Humidity Sensor Module with Cable
SKU: 618484- Input Supply Voltage (VDC): 3.3 ~ 5.
- Supply Current (mA): measurement 0.3mA standby 60μA.
- Temperature measurement range: 0~50 degrees.
- Temperature measurement error: ±2 degrees.
- Humidity measurement range: 20%~95%RH.
- Humidity measurement error: ±5%RH.
SKU: 618484 -
-
-
Digital Voltage, Current and Frequency Meter
22mm 0-100A Ac 20-500V Digital Voltmeter Ammeter- Blue
SKU: 975682- Voltage Measuring Range: AC 20 -500V
- Current Measuring Range: 0 -100A
- Panel Size: 31x31mm / 1.22×1.22inch
- Installation Diameter: 20.3mm / 0.8inch
- color: yellow/blue/white/green/red
- Material: Plastic
- size: 22mm
SKU: 975682 -
-
Buck Converter
AMS1117-5.0 LDO 800MA DC 5V to 3.3V Step-Down Power Supply Module
SKU: R100758- Output Voltage: 3.3V to 5V
- Output Current: 800mA
- Onboard AMS1117 chip.
- Onboard power indicator to indicate power is turned on: Red LED.
- Output voltage interface, connection to facilitate the experimental.
- Small Compact Size, 3Pin Type, Breadboard Friendly.
SKU: R100758 -
-
Flight Controller & Accessories
F3 EVO V2.0 Flight Control
SKU: 674161- Supported Receiver Input Signal: PPM, SBUS, DSM
- Support PPM, SBUS, DSM receiver input signal
- Battery voltage detection and buzzer interface
- Large current NMOS transistors, operating current can reach 10A or higher
- Use STM32F303CCT6 + MPU6500, advanced hardware platform F3 for higher flight stability
SKU: 674161 -
Battery Chargers, Ni-Mh | Li-po | Li-Ion Battery chargers
Common Sense RC Ac/Dc 6 Lipo Battery Balance Charger
Battery Chargers, Ni-Mh | Li-po | Li-Ion Battery chargersCommon Sense RC Ac/Dc 6 Lipo Battery Balance Charger
SKU: 1802999- Model: Common Sense RC Ac/Dc 6 Lipo Battery Balance Charger
- Input Voltage (V AC):110 ~ 240
- DC Input Voltage Range (V):11 ~ 18
- Output Power(Watt):50 W Max.
- Charge Current Range (A):0.1 ~ 5
- Maximum Discharge Power (W):5
- Discharge Current Range (A):0.1 ~ 1.0
- Drain Current for Balancing Li-Po’s (mA/Cell):300
- Li-ion/Po cell count:1 ~ 6
SKU: 1802999 -
-
Electronic Switches/Keypads Modules
Yellow Electronic Building Blocks Big Key Button Module High Level Output
Electronic Switches/Keypads ModulesYellow Electronic Building Blocks Big Key Button Module High Level Output
SKU: 1165467- Interface: Standard electronic block (GND, VCC, SIG)
- Working voltage: 2-5.5VDC
- Working Current: 0.55mA(MAX)
- Output: digital level (press high, release low)
- Great for DIY projects
SKU: 1165467 -
-
-
IMU, Accelerometer, Magnetometer & Gyroscope
GY-511 LSM303DLHC high-precision 3 Axis electronic compass acceleration sensor module
IMU, Accelerometer, Magnetometer & GyroscopeGY-511 LSM303DLHC high-precision 3 Axis electronic compass acceleration sensor module
SKU: 835808- Chip built-in 16-bit data output
- Operating Voltage: 3-5V DC
- Communication: I2C/IIC Protocol
- Accelerometer Range: ± 2 ± 4 ± 8 ± 16 g
- Magnetic Field Range:± 1.3 to ±8.1 gauss
SKU: 835808 -
Interfacing Cables
SATA3.0 to USB3.0, External Hard Disk Data, Cable :Line 45CM Long
SKU: 1121409- SATA 3.0 cable for SATA to USB data transfer.
- Ideal for 2.5″Â HDD and SSD external hard drive
- Data transfer with a speed of 6Gb/s or 600 Mb/s.
- Indicating LEDs for activity tracking.
- USB 3.0. It also supports USB 2.0/1.1.
- Cable Lenght: 25cm
SKU: 1121409 -
IR and RF Transmitters and Receivers
HackRF One
SKU: 1051957- 1 MHz to 6 GHz operating frequency
- half-duplex transceiver
- up to 20 million samples per second
- 8-bit quadrature samples (8-bit I and 8-bit Q)
- compatible with GNU Radio, SDR#, and more
- software-configurable RX and TX gain and baseband filter
- software-controlled antenna port power (50 mA at 3.3 V)
SKU: 1051957 -
-
-
-
3D Printer Extruder Parts and Fans
4mm x 6mm PTFE Teflon Tube for 3.0mm 3D Printer Filament
SKU: 1320771- Color: White
- Inner diameter: 4 mm
- Outer diameter: 6 mm
- It is used for the E3D V6 Extruder.
- Operating Temperature Range: -180°C to +260°C
- It has unique lubricity and the surface is no sticky.
- Material: PTFE
- Length: 1 Meter
SKU: 1320771
