IoT Development Boards
Showing 193–217 of 217 results
-
-
-
-
-
-
IoT Development Boards
Ai-Thinker ESP32-Audio-Kit Serial to WI-FI Development Board
SKU: 813193- Based on ESP32 Microcontroller
- Can Work As Minimum Independent System.
- Audio Interfaces Distributed On One Side.
- Dual-Core Xtensa LX6 CPU
- Up to 64Gb of Storage With Micro-SD Card.
Note: This product is about to be discontinued. You can check out for its alternative: SKU 1382870 Ai-Thinker Ai-WB2-01M Module
SKU: 813193 -
IoT Development Boards
Sipeed Maixduino Kit for RISC-V AI + IoT
SKU: 790008- Supply voltage of external power supply: 4.8V ~ 5.2V
- Supply current of external power supply :>600mA
- Temperature rise: <30K
- Frequency Range: 2400Mhz – 2483.5Mhz
- Onboard ESP32 module support 2.4G 802.11. b/g/n and Bluetooth 4.2
SKU: 790008 -
IoT Development Boards
Sipeed Maixduino for RISC-V AI + IoT
SKU: 790007- Supply voltage of external power supply: 4.8V ~ 5.2V
- Supply current of external power supply :>600mA
- Temperature rise: <30K
- Frequency Range: 2400Mhz – 2483.5Mhz
- Onboard ESP32 module support 2.4G 802.11. b/g/n and Bluetooth 4.2
SKU: 790007 -
IoT Development Boards
Sipeed MAIX-I module w/o WiFi ( 1st RISC-V 64 AI Module, K210 inside )
SKU: 755023- Up to 8 channels of audio input data, ie 4 stereo channels
- Simultaneous scanning pre-processing and beamforming for sound sources in up to 16 directions
- 16-bit wide internal audio signal processing
- Dual-core RISC-V 64bit IMAFDC, on-chip huge 8MB high-speed SRAM (not for XMR :D), 400MHz frequency
- Up to 192kHz sample rate
SKU: 755023 -
IoT Development Boards
Matrix Voice IoT Development Platform with ESP32 Wireless Module
SKU: 712428- Xilinx Spartan 6 XC6SLX9 FPGA
- 7 x MEMSMP34DB02 audio sensor digital microphone array
- 18 x RGBW LEDs
- 64MByte 132MHZ SDRAM
- 64Mbit Flash Memory
- Wifi 2.4Ghz 802.11bgn – BT 4.0 LE
- Tensilica Xtensa dual-core 32-bit LX6 microcontroller
SKU: 712428 -
-
IoT Development Boards
Microsoft’s Azure Sphere MT3620 Starter Kit
SKU: 712414- On-board environmental sensors for light, temperature, and barometric pressure
- Interface for optional OLED 128×64 display
- USB Interface for power and data with a host computer
- User pushbutton switches and LEDs
- 5V to 3.3V power regulation
- Terminal footprints for external 5V DC and VBAT supplies
SKU: 712414 -
-
-
IoT Development Boards
SeeedStudio LinkIt Smart 7688 Duo
SKU: 672585- 580 MHz MIPS CPU
- Single input single output(1T1R) Wi-Fi 802.11 b/g/n (2.4G)
- Pin-out for GPIO, I2C, SPI, SPIS, UART, PWM, and Ethernet Port
- 32MB Flash and 128MB DDR2 RAM
- USB host
- Micro SD slot
- Support for Arduino (ATmega32U4)
SKU: 672585 -
-
IoT Development Boards
LinkIt Connect 7681 – Wi-Fi HDK for IoT
SKU: 336555- Chipset Core: MT7681 ANDES N9
- Clock Speed: 80MHz
- Flash: 1MB, RAM: 64KB
- Power: on-board 1A 3.3V voltage regulator (can be powered from USB connector)
- Connectors: UART/GPIO/SPI pins are available on connectors (100mil/2.54mm pitch), micro USB connector.
- GPIO Voltage: 3.3V
- PWM Output pin Count: 5
- PWM levels: 0~20
- UART Voltage: 3.3V
- Wi-Fi Spec: 802.11 b/g/n for Station mode; 802.11 b/g for AP mod
SKU: 336555 -
IoT Development Boards
NANO32 ESP32 IoT Development Board
SKU: 24473-
ESP32 SoC (System on Chip) with WiFi and Bluetooth BLE
-
40MHz Crystal for CPU, 32.768KHz for RTC and low power operation
-
4MB Flash (32MBit)
-
FTDI231 for the USB to Serial communication
-
Auto-reset for automatic flash of new program
-
On board 3.3V, 0.5A LDO, tested to work upto 1A
-
2.5dBi Peak Gain, 0.5dBi averange gain antenna
SKU: 24473 -