This is BIGTREETECH BTT Manta M8P Control Board.
BIGTREETECH Manta M8P Control Board uses 32-bit ARM Cortex-M0+ series STM32G0B1VET6 main control chip with a core frequency of 64MHz. High-performance MOSFETs are used to reduce heat generation. The power chip of Manta M8P integrated main control board adopts TPS5450-5A, which supports DC12/24V power input; the output current of this chip is up to 5A, and the peak value can reach 6A, which perfectly supports the power supply of Raspberry Pi.
The control board and the core board use BTB connection method, so that other core board solutions other than CM4 can be selected, such as BIGTREETECH CB1. The mainboard reserves the SPI expansion interface for using the Klipper firmware to connect an external acceleration sensor for acceleration compensation. The thermistor can select the pull-up resistance value through the jumper, which supports PT1000 without external modules, which is convenient for DIY use; the control board reserves a three-way four-wire fan interface, which can be used to connect a water-cooling device.
Note: Actual product may vary in color. Refer to Manual in the ATTACHMENTS section for more info. regd. the product.
Features:
- The MCU firmware can be updated via an SD card, or through Klipper’s make flash command using DFU;
- The motherboard and the core board use the BTB connection to allow using other solutions other than CM4;
- On-board TMC-driver SPI and UART working modes, on-board DIAG function pins, can be used by simply plugging and unplugging the jumper cap;
- Support filament runout detection, auto shutdown, BLTouch, RGB lights…
- High efficiency MOSFET for less heat generation;
- Adopt replaceable fuse for easy replacement;
- Three-way four-wire fan interface is reserved, and can be used to connect the water cooling device;
- Provide the SPI expansion interface to allow Klipper firmware users to connect an external acceleration sensor for acceleration compensation
Package Includes:
1 x BIGTREETECH Manta M8P Control Board
1 x Type C USB Cable
1 x DIY Crimp Terminal Set
1 x Black jumper set
There are no reviews yet.