Generic
Showing 625–672 of 6083 results
-
-
LED Module
DIP 3 Color LED Module
SKU: 44177- The use of plug-in full-color LED.
- RGB trichromatic limiting resistor to prevent burnout.
- Through the PWM adjusting, three primary colors can be mixed to obtain different colors.
- With a variety of single-chip interface.
- The working voltage: 5V.
- LED drive mode: common cathode driver
SKU: 44177 -
Current and Voltage Sensor, Hall Sensor
ACS758LCB-050B Hall-Effect-Based Linear Current Sensor IC
SKU: 559742- Integrated shield greatly reduces capacitive coupling from the current conductor to die due to high dV/dt signals, and prevents offset drift in high-side, high-voltage applications.
- Total output error improvement through gain and offset trim over temperature.
- Small package size, with easy mounting capability.
- Monolithic Hall IC for high reliability.
- Output voltage proportional to AC or DC currents.
- Factory-trimmed for accuracy.
- Extremely stable output offset voltage.
- Nearly zero magnetic hystereses.
SKU: 559742 -
4S Li-ion BMS
4 Series 40A 18650 Lithium Battery Protection Board 14.8V 16.8V with Balance for Drill Motor Lipo Cell Module
4S Li-ion BMS4 Series 40A 18650 Lithium Battery Protection Board 14.8V 16.8V with Balance for Drill Motor Lipo Cell Module
SKU: 223535- The Successful start of the drill requires three 15C-20C power battery, or six 10C-15C power battery (ordinary 18650 cannot start the drill!!)
- Strictly according to map wiring 0V, 4.2V, 8.4V, 12.6V, 16.8V, do not deliberately short circuit.
SKU: 223535 -
-
Drone Motor
A2212 1000 KV Brushless DC Motor with SimonK 30A ESC and Orange 1045 Propeller Set
SKU: 5923- Offers great performance and value for money.
- Suitable for airplane, aircraft, quadcopter.
- Motor KV: 1000
- LiPO Batteries: 2S-3S
- Shaft Diameter: 3.17 mm
- ESC used has an On-Board BEC.
- Propeller: Orange HD 1045
SKU: 5923 -
-
-
-
-
-
Buck Converter
XL4015 5A Step Down Adjustable Power Supply with LED Voltmeter
SKU: 12253- Better than 2596, easy to 4A 50W, up to 75W adding the heat sink.
- Over-temperature protection: Yes (shutdown output automatically after over temperature).
- Input voltage: 4V ~ 38V (not more than 38V).
- Output voltage: 1.25V ~ 36V (adjustable).
- Output current: 0A ~ 5A (recommended below 4.5A).
SKU: 12253 -
-
Raspberry Pi Accessories
Ultra-thin Raspberry PI Routing Chip Radiator with Thermal Adhesive Size: 30x40x5MM
Raspberry Pi AccessoriesUltra-thin Raspberry PI Routing Chip Radiator with Thermal Adhesive Size: 30x40x5MM
SKU: 1150788- Product: Routing Chip Radiator
- Material: aluminum
- Color: Black
- Teeth Number: 7 rows and 14 columns
- Compatible with most Raspberry Pi cases
- Suitable for Auxiliary heat for Raspberry pi 2 model B/Raspberry Pi B+.
SKU: 1150788 -
-
Logic Level Converter
CJMCU-4051 74HC4051 8 Channel Analog Multiplexer/Demultiplexer Breakout Board for Arduino
Logic Level ConverterCJMCU-4051 74HC4051 8 Channel Analog Multiplexer/Demultiplexer Breakout Board for Arduino
SKU: 445801.Wide Analog Input Voltage Range: +/-5V
2.Low “ON” Resistance: 80 ohm (type) at Vcc = 4.5V; 70 ohm (type) at Vcc = 6.0V; 60 ohm (type) at Vcc = 9.0V
3.Logic Level Translation: to enable 5V to communicate with +/-5V analog signals
4.Board Size: 30 x 19 mmSKU: 44580 -
-
GPS Modules
25x25x8mm 28db High Gain 5cm Length Built-in Ceramic Active GPS Antenna for NEO-6M NEO-7M NEO-8M
GPS Modules25x25x8mm 28db High Gain 5cm Length Built-in Ceramic Active GPS Antenna for NEO-6M NEO-7M NEO-8M
SKU: 1150670- Product: ceramic antenna cable
- Frequency: 1575.42MHz ± 4 MHz
- Antenna gain: 28dB
- Operating temperature: -45 ~ +85
- Polarization: right-hand circular polarization
- Interference suppression: 30dB ± 100MHz
- Weight: 15g
SKU: 1150670 -
-
-
-
-
Boost Converter
LM2577 DC-DC Step-Up Power Converter Module
SKU: 699580- Wide Input voltage: 3.5V-35V
- Output Voltage: 4-35V (Adjustable)
- Output current: rated current 3A MAX ( Heat-sink Needed)
- Conversion efficiency: Up to 92% (output voltage higher, the higher the efficiency)
- Switching Frequency: 50KHz
SKU: 699580 -
-
